Black and Decker Surge Xpress Iron X560X690 User Manual

®
SAVE THIS USE AND CARE BOOK
LEASE ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO
CONSERVER CE GUIDE D’ENTRETIEN ET D’UTILISATION
Séries X500-X600 Series
SurgeXpress
™
Iron (English)
Plancha (Espãnol)
Fer(Français)
Black & Decker, S.A. de C.V. 120 V~  1200 W  60 Hz
?
U.S.A. 1-800-231-9786
MEXICO 9-1-800-50833
CANADA 1-800-465-6070
http://www.blackanddecker.com 

IMPORTANT SAFEGUARDS
When using your iron, basic safety precautions should always be fol-
lowed, including the following:
READ ALL INSTRUCTIONS.
Use iron only for its intended use.
To protect against a risk of electric shock, do not immerse the iron in
water or other liquid.
The iron should always be turned to Fill before plugging into or
unplugging from an outlet. Never yank cord to disconnect from outlet;
instead grasp plug and pull to disconnect.
Do not allow cord to touch hot surfaces. Let iron...

dropped or damaged. To avoid the risk of electric shock, do not disas-
semble the iron; instead, take it to an authorized service center for
examination and repair. Incorrect reassembly can cause a risk of elec-
tric shock when the iron is used.
Close supervision is necessary for any appliance being used by or
near children. Do not leave iron unattended while connected or on an
ironing board.
Burns can occur from touching hot metal parts, hot water, or steam.
Use caution when you turn iron upside down...

SAVE THESE INSTRUCTIONS
TAMPER-RESISTANT SCREW
This appliance is equipped with a tamper-resistant screw to prevent removal of
the outer cover.  To reduce the risk of fire or electric shock, do not attempt to
remove the outer cover.  There are no user serviceable parts inside.  Repair
should be done only by authorized service personnel.
POLARIZED PLUG
This appliance has a polarized plug—one blade is wider than the other. To
reduce the risk of electric shock, this plug will fit into a polarized outlet...

Service, if necessary, must be performed by a Black & Decker Household
Appliance Company-Owned or Authorized Service Center. The Service Center
nearest you can usually be found in the yellow pages of your phone book under
“Appliances-Small-Repairing” or call the appropriate toll-free “800” number on
the cover of this book. 
Before shipping or mailing your iron, empty all water from the iron while it’s hot.
Be sure it is completely cool before packing for shipment. Pack it carefully into a
sturdy carton...

For Household Use Only
Utilisation domestique seulement
-
-
-
replace it free of charge. We will return your product, transportation charges
prepaid, provided it is delivered prepaid to any Black & Decker Household
Appliance Company-Owned or Authorized Service Center.This warranty
gives you specific legal rights and you may also have other rights which
vary from state to state or province to province. Answers to any ques-
tions regarding warranty or service may be obtained by calling toll free, in
the...

1. Spanish/French Fabric Guide
2. ON/OFF Button/Auto-Off Light
3. Setting Indicator
4. Water Tank
5. Full-Length Button Groove 
6. Water Fill Hole7. Push to Clean Setting 
8. Adjustable Steam Knob
9. Spray Button
10. Surge of Steam Button
11. Heat/Fabric (Guide) Dial
12. Cordset and Cord Wrap 
1. Guide des tissus
2. Interrupteur (ON/OFF)/Témoin 
d’arrêt automatique
3. Indicateur de réglage
4. Réservoir
5. Rainure pleine longueur pour 
les boutons
6. Orifice de remplissage7. Réglage pour l’autonettoyage...

NOTE: Before first use, remove any labels or stickers on the body or soleplate
of the iron.  On first use only, iron over an old cotton cloth using steps 1 thru 5
below on setting 3 or above (and the Surge button) to remove any protective
surface treatments.
1. Using a clean cup, pour water into one of the two openings in the Water Fill
Hole until the level reaches the top of on the Water Window. Do not 
overfill.  Refill as needed.
2. Ordinary tap water can be used for ironing.  Do not use water...

3. Plug in the iron.  For models with Automatic Shut-Off, push the ON/OFF button
and a light will come on (A).  For all models, turn the Heat/Fabric Dial to the
appropriate setting for your fabric (B). On models without Auto-Off, the light
will cycle on and off when the iron is on.  Always stand the iron on its heel
rest when powered on but not in use.
4. Use the Fabric Guide on the iron (see B) to select the proper temperature set-
ting for the fabric to be ironed (check the garment label for fabric...

the Heat/Fabric Dial to FILL,unplug, allow to cool, and store on heel rest.
Wrap the cord, and clip in place. (C)
STEAM IRONING
Be sure the Heat/Fabric Dial is set within the Steam area (between settings 3-7)
and there is water in the Water Tank.  Turn the Adjustable Steam Knob (D) to
the  (light),  (medium), or  (heavy) steam setting for your fabric
as indicated in the puff band over the fabric setting (see B).  If water spotting
occurs, turn the Heat/Fabric Dial to a slightly higher setting or set...