Black and Decker Steam Dry Iron F300F394SW User Manual

SAVE THIS USE AND CARE BOOK
LEASE ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO
CONSERVER CE GUIDE D’ENTRETIEN ET D’UTILISATION
Steam & Dry Irons
Planchas de vapor y secas / Fers à vapeur à sec 
Série F300 Series 
?
U.S.A  1-800-231-9786
MEXICO 9-1-800-50833
CANADA  1-800-465-6070
http://www.blackanddecker.com
ENGSPAN.FRN.ENGSPAN.FRN.ENGSPAN.FRN.ENGSPAN.FRN.ENGSPAN.FRN.ENGSPAN.FRN.ENGSPAN.FRN.
POLARIZED PLUG
This appliance has a polarized plug—one blade is wider than the other. To
reduce the risk of...

IMPORTANT SAFEGUARDS
When using your iron, basic safety precautions should always be fol-
lowed, including the following:
READ ALL INSTRUCTIONS.
Use iron only for its intended use. 
To protect against a risk of electric shock, do not immerse the iron in
water or other liquid.
The iron should always be turned to O/FILL before plugging into or
unplugging from an outlet. Never yank cord to disconnect from outlet;
instead grasp plug and pull to disconnect.
Do not allow cord to touch hot surfaces. Let...

Always disconnect iron from electrical outlet when filling with or
emptying of water and when not in use.
Do not operate iron with a damaged cord or plug or if the iron has been
dropped or damaged. To avoid the risk of electric shock, do not disas-
semble the iron; instead, take it to an authorized service center for
examination and repair. Incorrect reassembly can cause a risk of elec-
tric shock when the iron is used.
Close supervision is necessary for any appliance being used by or
near children....

SPECIAL INSTRUCTIONS
To avoid a circuit overload, do not operate another high-wattage
appliance on the same circuit.
If an extension cord is absolutely necessary, a 10-ampere rated cord
with a polarized plug and UL, CSA, or NOM approval should be used.
Cords rated for less amperage may overheat. Care should be taken to
arrange the cord so that it cannot be pulled on or tripped over.
SAVE THESE INSTRUCTIONS
TAMPER-RESISTANT SCREW
This appliance is equipped with a tamper-resistant screw to prevent...

For Household Use Only
Utilisation domestique seulement
SERVICE OR REPAIR
Service, if necessary, must be performed by a Black & Decker Household Appliance
Company-Owned or Authorized Service Center. The Service Center nearest you can
usually be found in the yellow pages of your phone book under “Appliances-Small-
Repairing” or call the appropriate toll-free “800” number on the cover of this book. 
Before shipping or mailing your iron, empty all water from the iron while it’s hot. Be sure it
is completely...

FULL TWO-YEAR WARRANTY
Black & Decker warrants this product against any defects that are due to faulty
material or workmanship for a two-year period after the original date of consumer
purchase or receipt as a gift. This warranty does not include damage to the product
resulting from accident or misuse. If the product should become defective within the
warranty period, we will repair it or elect to replace it free of charge. We will return
your product, transportation charges prepaid, provided it is...

1. Orifice de remplissage
2. Pulvérisateur 
3. Sélecteur de température 
4. Bouton de vaporisation 
5. Bouton de pulvérisation 
6. Guide des tissus7. Indicateur de niveau d’eau
8. Enrouleur de cordon / Talon 
d’appui stable
9. Rainures pleine-longueur pour les
boutons  


 	


F394S Shown / Ilustrada / Illustré
7
1. Water Fill Hole
2. Spray Nozzle 
3. Temperature Selector Dial4. Steam Button
5. Spray Button
6. Fabric Guide7. Water Window
8. Cord Wrap/Stable Heel Rest
9.  Full-Length Button Groove...

NOTE: Before first use, remove any labels or stickers, on the body or sole-
plate of the iron.  On first use only, iron over an old cotton cloth using steps
1 thru 5 below on setting 5 or above with the Steam Button in the Up posi-
tion to remove any protective surface treatments.
1. With the iron unplugged and the Steam Button latched in the down position,
use a clean cup and pour approximately 3/4 cup water into one of the two
openings in the Water Fill Hole. For models with a Water Window, fill until...

2. Ordinary tap water can be used for
ironing.  Do not use water processed
through a home softening system.  In
extremely hard water areas, consider
using distilled or demineralized water,
however, use tap water the first time
you use the iron and once a month
thereafter to maintain steam perfor-
mance.
3. Plug in the iron and move the
Temperature Selector Dial to the
appropriate setting for your fabric (B).
Always stand the iron on its heel rest
when powered on but not in use.
4. Use the Fabric Guide on...

STEAM IRONING
Be sure there is water in the reservoir. Turn the Temperature Selector Dial
between settings 4 and 7. Unlatch the Steam Button to the Up position.  If
steam doesnt start, gently bump the soleplate on the ironing board a few
times. If water drips from vents, turn the dial to a higher setting.
SPRAY (Selected Models Only)
Check to be sure the iron is filled with water. Push the SPRAY button to dampen
tough wrinkles at any setting. 
DRY IRONING
Turn the Temperature Selector Dial to the desired...