Bissell 3576 6 Manual

							1.
Determine the light bulb type of your vacuum: 
Standard Bulb (#203-1297) – approximately 1” long, flat end  
Large Bulb (#203-1007) – approximately 2” long, round end
Standard Bulb – remove the bulb from the socket by grasping 
bulb and pulling straight out. Install the new bulb by pushing it 
gently into the socket until the bulb snaps into place. 
Large Bulb - remove the bulb from the socket by pushing 
bulb in gently and turning it towards brush. Install the new 
bulb by pushing it gently into the socket and turning away 
from the brush.
Reposition lens by inserting the tab on left side and then 
pushing the right side back into place.
Select Models Only
The TurboBrush should be checked regularly for 
clogs or debris wrapping around the brush roll.
Unplug vacuum from electrical outlet.
If a clog is present or debris is visible, unscrew the two 
screws on the back of the TurboBrush to remove the   
faceplate and clear any obstructions.
To clean debris from the brush roll, remove the screw 
located on the belt cover. Lift the belt cover. Remove the 
brush roll from the drive belt and clean debris.
Reposition the drive belt on the brush roll. Place ends 
of brush roll in slots on sides as shown. Reposition belt 
cover and secure with shorter screw. Reposition faceplate 
and secure with two longer screws.
Low suction, poor pickup, or no suction may be due to 
a clog in the vacuum cleaner. If you notice a change in 
the sound of the motor or a reduction in the spinning 
action in the Dirt Container, check for clogs.
Unplug cleaner from electrical outlet.
Empty Dirt Container.
3.
Replace Lightbulb Continued
11
4.
5.
1.
2.
TurboBrush Maintenance
Standard Bulb
Large Bulb
Clearing Clogs
1.
2.
3.
4.
Belt Cover 
						

							1.12
Troubleshooting
Vacuum cleaner won’t run
Possible Causes Remedies
 Power cord not plugged in   Check electrical plug
  Blown fuse/tripped breaker   Check/Replace fuse or   
     reset breaker
Vacuum cleaner won’t pick up dirt
Possible Causes Remedies
  Incorrect Height Adjustment   Adjust Powerfoot to correct   
     height setting
  Hose not attached to suction opening    Grasp Quick Reach Handle and  
     firmly push Hose Wand onto the   
     suction opening
  Twist ‘n Snap Hose not securely attached.    Make sure Twist ‘n Snap Hose is   
     snapped into locked position
  Crack or hole in Hose   Check Hose and replace if needed
  Broken or worn Drive Belt   Replace Drive Belt, see pg. 9-10
  Rotating Floor Brush bristles worn   Replace brush
  Rotating Floor Brush jammed   Remove brush and clean debris from   
     brush ends
  Clog in vacuum    Clear clog, see pg. 11-12 
  Dirt Container full   Empty Dirt Container
11
22
11
22
33
44
55
 
WARnInG:   To reduce the risk of injury from moving 
parts and/ or electrical shock, turn Power 
Switch OFF and disconnect polarized plug 
from electrical outlet before performing 
troubleshooting checks.
5.
6.
Suction Inlet
Air Passageway
Louvers
Hose Wand Base
Check Upper Tank and Louvers for build up or clogs.  
Check to make sure Louvers are installed correctly. To 
unlock the Louvers, grasp the rim and turn toward the left. 
Pull straight down to remove. If the Louvers are  
missing or not locked into place, check and clear the tube 
in the center of the Dirt Container.
Remove the Twist ‘n Snap Hose from the vacuum by  
turning to the left. Check the Suction Inlet, Hose and Hose 
Wand for clogs. Remove any clogs from the hose using a 
long, narrow object.
Check the Foot Hose for clogs. If needed, remove the screw 
attaching the Hose Wand Base to the vacuum. Straighten 
the Foot Hose and unclog with a long, narrow object.
If the clog persists, follow the instructions for Checking 
the Rotating Floor Brush on page 9-10 and inspect the Air 
Passageway for obstructions.3.
4.
Clearing Clogs Continued
66
77
88
99 
						

							1.
Vacuum cleaner won’t pick up dirt continued
Possible Causes Remedies
 Dirt Container not installed properly    Position correctly and lock in place
  Filters are dirty   Check and clean Inner and Outer   
     Circular Filters, Pre-Motor and   
     Post-Motor Filters
  Louvers missing or installed incorrectly    Check for a clog in the tube in the  
     center of the Dirt Container, clear  
     and properly install Louvers 
Tools won't pick up dirt
Possible Cause  Remedies
 Crack or hole in Hose   Check Hose and replace if needed
  Clog in vacuum    Clear clog, see pg. 11-12
  Dirt Container full   Empty Dirt Container
  Dirt Container or Upper Tank    Position correctly and   
  not installed properly   lock in place
  Filters are dirty   Check and clean Inner and Outer  
     Circular filters, Pre-Motor and   
     Post-Motor Filters
  Louver missing or installed incorrectly    Check for a clog in the tube in the  
     center of the Dirt Container, clear  
     and properly install Louvers 
Vacuum cleaner is difficult to push
Possible Causes  Remedies
 Incorrect Height Adjustment   Adjust Powerfoot to correct   
     height setting
  Brush Cover installed incorrectly   Make sure all four screws are in   
     place or all three latches are secured
Visible dirt escaping from cleaner
Possible Causes  Remedies
 Dirt Container full   Empty Dirt Container
  Filters missing or installed incorrectly    Check Inner and Outer Circular  
     Filters and Post-Motor Filter for   
     correct installation
  Dirt Container installed incorrectly   Pull out and re-insert Dirt   
     Container correctly
  Filter Cup installed incorrectly   Remove Dirt Container and make   
     sure Filter Cup is fully attached
If suggested solutions do not correct the problem, call:
 BISSELL Consumer Services
Troubleshooting Continued
13
33
44
55
66
11
11
22
33
22
44
1010
1111
1212
11
22 
						

							1.14
Replacement Parts – BISSELL Cleanview II Series
12/34
7
56
8/9101112
1415161713
7
You may purchase replacement parts from your retailer, by calling BISSELL Consumer Services 
or by visiting our website. To locate a retailer near you, or to place an order using Visa, 
MasterCard, Discover or American Express, call
BISSELL Consumer Services
1-800-237-7691 
Monday - Friday 8 a.m. — 10 p.m. ET
Saturday    9 a.m. — 8 p.m. ET
Or visit our Website - www.bissell.com
 
Item  Part no.  Part name
 1  32074  Style 7/9/10 Drive Belt (2-Pack)
 2    203-1007  Large Headlight Bulb (Select Models Only)
 3    203-1297  Standard Headlight Bulb (Select Models Only)
  4    203-1063   Crevice  Tool
 5    203-1099  Combination Dusting Brush / Upholstery Tool 
  6    203-1084   Extension  Wand
 7    203-1227  TurboBrush (Select Models Only)
 8    203-1220  Wire Reinforced Twist ‘n Snap Vacuum Hose Gray 
 9    203-1221  Wire Reinforced Twist ‘n Snap Vacuum Hose Clear 
10    203-2032   Brush  Roll
11   203-1195    Wide Brush Roll (Select Models Only)
12   32064  Style 9/10 Inner & Outer Circular Filter Set
13   32065  Style 9/10 Inner Circular Filter only
14   203-1192  Style 9/10 Outer Circular Filter only
15   203-1215  Style 9/10 Pre-Motor Filter 
16   3099  Style 7/9 Post-Motor Filter (2 pack)
17   32076  Style 7/9 Post Motor Filter (Select Models Only)  
						

							1.
BISSELL Consumer Services
For information about repairs or replacement parts, or  
questions about your warranty, call:
BISSELL Consumer Services
1-800-237-7691 
Monday - Friday  8 a.m. — 10 p.m. ET
Saturday    9 a.m. — 8 p.m. ET
Or write:
BISSELL Homecare Inc.
PO Box 3606
Grand Rapids,  MI 49501
ATTN:  Consumer Services   
Or visit the BISSELL website - www.bissell.com
When contacting BISSELL, have model number of unit available.
Please record your Model Number: ___________________
Please record your Purchase Date:  ___________________
nOTE: Please keep your original sales receipt. It is your warranty.
15
Registering is quick, easy and offers you benefits over the lifetime of \
your product.   
You’ll receive:
BISSELL Rewards Points
Automatically earn points for discounts and free shipping on future purchases.
Faster Service
Supplying your information now saves you time should you need to contact us with 
questions regarding your product.
Product Support Reminders and Alerts
We’ll contact you with any important product maintenance reminders and alerts.
Special Promotions
Optional: Register your email to receive notice of offers, contests, cle\
aning tips and more!
Visit www.bissell.com/registration now!
Don't forget to register your product! 
						

							1.
Warranty
16
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to 
state. If you need additional instruction regarding this warranty or have ques\
tions regarding what it may cover, 
please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below.
Limited One y ear Warranty
Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL Homecare 
Inc. will repair or replace (with new or remanufactured components or produ\
cts), at BISSELL’s option, free of 
charge from the date of purchase by the original purchaser, for one year any defective or malfunctioning part.
See information below on "If your BISSELL product should require service".
This warranty applies to product used for personal, and not commercial or rental service. This warranty does not 
apply to fans or routine maintenance components such as filters, belts, or brushes. Damage or malfunction caused 
by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the User's Guide is   
not covered
. 
If your BISSELL product should require service:
Contact BISSELL Consumer Services to locate a BISSELL Authorized Service Center in your area. 
If you need information about repairs or replacement parts, or if you have questions about your   
warranty, contact BISSELL Consumer Services.
Website or E-mail:  
www.bissell.com  
Use the “Customer Services” tab
.
Or Call:  
BISSELL Consumer Services  
1-800-237-7691  
Monday - Friday 8 a.m. - 10 p.m. ET  
Saturday 9 a.m. - 8 p.m. ET 
Or write:  
BISSELL Homecare Inc.  
PO Box 3606  
Grand Rapids MI 49501  
ATTN: Consumer Services
BISSELL HOMECARE InC. IS nOT LIABLE FOR InCIDEnTAL OR COnSEQUEnTIAL DAMAGES OF Any 
nATURE ASSOCIATED WITH THE USE OF THIS PRODUCT. BISSELL’S LIABILITy WILL nOT EXCEED THE 
PURCHASE PRICE OF THE PRODUCT. 
Some states do not allow the exclusion or limitation of incidental or co\
nsequential damages, so 
the above limitation or  
exclusion may not apply to you. 
*EXCEPTIOnS AnD EXCLUSIOnS FROM THE TERMS OF THE LIMITED WARRAnTy
THIS WARRAnTy IS EXCLUSIVE AnD In LIEU OF Any OTHER WARRAnTIES EITHER  
ORAL OR WRITTEn. Any IMPLIED WARRAnTIES WHICH MA y ARISE By OPERATIOn  
OF LAW, InCLUDInG THE IMPLIED WARRAnTIES OF MERCHAnTABILITy AnD  
FITnESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE OnE yEAR DURATIOn  
FROM THE DATE OF PURCHASE AS DESCRIBED ABOVE.
Some states do not allow limitations on how long an implied warranty las\
ts,  
so the above limitation may not apply to you.
©2013 BISSELL Homecare Inc
Grand Rapids, Michigan
All rights reserved. Printed in Korea
Part Number 110-4303
Rev 9/13 
Visit our website at:
www.bissell.com