Bisell Healthy Home Vacuum 6100E User Manual

Replacing the HEPa filter cartridge
the HEP a filter cartridge should be 
replaced every six months or if suction   
is declining. More or less frequent   
replacing may be required based on 
individual vacuuming habits and types of 
debris picked up.
note:  to have the benefits of the 
airetight
™ HEP a System, you must 
use the  bISSEll HEP a filter cartridge.
1.   To remove the HEPA filter cartridge, 
push down on the filter door latch and 
pull door away from the cleaner.
2.   Lift the tab at the top...

clearing clogs
low suction or poor pickup may be due to 
a clog in the vacuum cleaner. If you notice 
a change in the sound of the motor or a 
reduction in the spinning action in the dirt 
container, check for a clog.
If there is no suction or if suction is reduced 
at the hose, follow these steps to check for 
and clear the clog:
1. Unplug cleaner from electrical outlet.
2.  Check the foam filter and clean as   
necessary (see cleaning the foam filter 
on page 10).  
3.  Check the HEPA filter and...

clearing clogs continued
If suction is normal at the hose, follow these steps 
to check for and clear the clog for floor cleaning:
1.  Check diverter area at back of machine for 
diverter position and clogs. When the hose 
wand is inserted in the base, the diverter 
should be down. If a clog is visible near the 
diverter, the plastic cover may be removed to 
clear the clog by removing the 7 screws as 
shown in illustration 8b on page 12.
2.   Check the foot hose for clogs (2a). If you are 
not able to...

14www.bissell.com
Maintenance and care
Brush reset
If something becomes lodged in the foot and 
the brush shuts off, turn the cleaner off and 
unplug from the electrical outlet. Remove the 
obstruction. the brush will automatically reset 
when the cleaner is plugged in and turned 
back on.
Brush maintenance
t he rotating brush should be checked regularly 
for accumulating debris that might reduce the 
cleaning performance of your vacuum.
1.  Unplug cleaner from electrical outlet.
2.  Recline the handle...

15www.bissell.com
Changing the light bulb
1. Unplug cleaner from electrical outlet.
2.  Recline handle for easier access to light bulb 
and remove screw to lift off lens.
3.  Remove the bulb by grasping bulb and pulling 
straight out of the socket. Install the new bulb 
by pushing gently into the socket until the 
bulb snaps into place.
TurboBrush maintenance
the  turbo brush should be checked regularly for 
clogs or debris wrapping around the brush.
1.  Remove tool from hose or front of vacuum.
2....

16www.bissell.com
Troubleshooting
Vacuum cleaner won’t turn on
Possible causes Remedies
1. Power cord not plugged in  1. Check electrical plug
2.  Thermal protector activated  2. Allow cleaner to cool for 30 minutes, see   
    page. 13
3.  Handle not fully attached  3. Remove handle and reinstall
brush not rotating
Possible causes    Remedies
1. Brush switch turned to “OFF”  1. Make sure brush switch is in “ON” position
2.  Vacuum is in upright position  2. Recline vacuum to operate brush
3.  Brush is...

Troubleshooting
17www.bissell.com
Vacuum cleaner is difficult to push
Possible causes Remedies
1.  Incorrect height setting  1. Turn dial to higher setting
Visible dust escaping from cleaner
Possible causes  Remedies
1. Filter tray missing or not installed properly  1. Check filter tray to make sure it is   
    fully inserted
2.  Foam filter missing or not installed properly   2. Check for foam filter and correct installation
3.   HEPA filter cartridge missing or not installed properly  3. Check for...

18www.bissell.com
BISSELL Consumer Services
If your bISSEll product should require service:In the UK, Australia or New Zealand, call BIssell Consumer  services at the numbers below and we will give  
you the location of a BIssell Authorized  service Center in your area. for all other countries, contact your local   
in country distributor for questions, service, or repair. 
If you have questions about your warranty or need replacement parts please contact the numbers below.
Or visit the BISSELL website -...

19www.bissell.com
below is a list of common replacement parts. While not all of these parts may have come 
with your specific model, they are available for purchase if desired.  Please note, all  
attachments may not store on board your vacuum.
Item  Part no.  Part name
1  3282   hePA filter Cartridge
2  203-1374  foam  filter
3  203-1362  TurboBrush
4  203-1381  Wide TurboBrush
5  203-1367  Pet Wide TurboBrush
6  203-1364  Telescoping Wand
7  203-1373  metal Telescoping Wand
8  203-1365  Combination...

 This warranty gives you specific legal rights, and you may also have other rights which may vary from country 
to country. If you need additional instruction regarding this warranty or have questions regarding what it may 
cover, please contact BIssell Consumer  services by telephone, or regular post as described below, or   
contact your local in country distributor.
 limited  two  year Warranty
 subject to the *eXCePTIoNs AND  eXClUsIoNs identified below, BIssell homecare, Inc., will replace (with...