BenQ Projector MX768 User Manual

Operation61 vii. You can select Video or Graphic display mode. Graphic Mode: worse image 
quality but faster tramsmission speed. Video Mode: better image quality but 
slower transmission speed. However, the actual transmission performance was 
determined by the status of network usage at that time.
viii. You can select whether to automatically open the Q Presenter application when 
the computer is powered on.
ix. Once set, press Apply to save the changes.
x. You can link to the BenQ remote network...

Operation 62
Using the broadcassting function
When it comes to 1:N LAN Dispaly,there are two ways to do this function:
1. By TCP/IP (support up to 8 porjectors, original design)
2. By Multicast(support up to 255 projectors, this new design)
You can select channel 1, 2, 3, 4, 5,6...25 with showing the corrspondent IP(gray out).
There are 1~25 channels (25IPs) for you to select freely:
239.192.19.21~239.192.19.45
If the channel is fixed at emergency channel, when projector detects image coming in from...

Operation63
Remote Desktop Control through Q 
Presenter
The Q Presenter can proceed the Remote Desktop Control (RDC) the host PC from 
projector site.
1. Setup the RDC login account (User name and Password ) in Q Presenter.
• Name: must be 8 English capital letters A~Z and number 0 ~9.
• Password: must be 6 digits and limit the range from 1~4.
• If there are lot of audience is watching the display while the user is entering the 
password, the number will be transferred to up, left, down, right in order...

Operation 642. Activate Remote Desktop Control Function in Q Presenter > Settings > Basic 
Settings.
3. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Network 
Settings menu. Press MODE/ENTER.
4. Select Remote Desktop and press MODE/
ENTER.
5. Enter the Account and Password the same as 
step 1.
6. Select Connect and press MODE/ENTER to 
connect the selected PC.
7. Connect USB keyboard or mouse to control the 
host PC’s desktop through the projector.
• Remote Desktop Control does not support PC...

Operation65 To view your pictures as a slideshow, follow these steps:
1. Connect a USB flash drive to your computer and copy files from your computer to 
the USB flash drive.
2. Turn on your projector if needed.
3. Remove the USB flash drive from your computer and plug it into the USB TYPE-A 
jack of the projector.
4. Select USB Reader from the source selection bar.
5. Press MODE/ENTER to enter the thumbnail display.
USB Reader menu
The USB Reader menu will display only when USB Reader source is...

Operation 66
Shutting down the projector
1. Press Power on the projector. A 
confirmation message displays prompting you. 
If you dont respond in a few seconds, the 
message will disappear. If you use the remote 
control, press OFF to shut down the projector.
2. Press Power on the projector a second 
time. The POWER indicator light flashes 
orange, the projection lamp shuts down, and 
the fans will continue to run to cool down the 
projector. 
• To protect the lamp, the projector will not respond 
to any...

Operation67
Menu operation
Menu system
Please note that the on-screen display (OSD) menus vary according to the signal type 
selected.
Main menu Sub-menu Options
1. 
DISPLAY
Wall ColorOff/Light Yellow/Pink/Light Green/
Blue/Blackboard
Aspect Ratio Auto/Real/4:3/16:9/16:10
2D Keystone
Corner Fit
Surface FitHorizontal 
Surface Fit
Vertical Surface 
Fit
Position
Phase
H. Size
Digital Zoom
3D3D modeAuto/Top Bottom/Frame 
Sequential/Frame Packing/Side by 
Side/Off
3D Sync Invert Disable/Invert
Save 3D...

Operation 68
2. 
PICTURE
Picture ModeDynamic/Presentation/sRGB/Cinema/(3D)/User 1/
User 2
Reference Mode Dynamic/Presentation/sRGB/Cinema/(3D)
Brightness
Contrast
Color
Tint
Sharpness
Brilliant ColorOn/Off
Color 
TemperatureCool/Normal/Warm
Color 
Temperature 
Fine TuningR Gain/G Gain/B Gain/R Offset/G 
Offset/B Offset
3D Color 
ManagementPrimary Color R/G/B/C/M/Y
Hue
Saturation
Gain
Reset Picture 
SettingsCurrent/All/Cancel
3. SOURCEQuick Auto Search On/Off
Color Space Conversion Auto/RGB/YUV 

Operation69
4. 
SYSTEM 
SETUP: 
Basic
Presentation 
TimerTimer Period1~240 minutes
Timer Display Always/1 min/2 min/3 min/Never
Timer PositionTop-Left/Bottom-Left/Top-Right/
Bottom-Right
Timer Counting 
DirectionCount Down/Count Up
Sound ReminderOn/Off
On/Off Yes/No
Language
Projector 
InstallationFront Table/Rear Table/Rear 
Ceiling/Front Ceiling
Menu SettingsMenu Display 
Time5 secs/10 secs/20 secs/30 secs/
Always
Menu PositionCenter/Top-Left/Top-Right/
Bottom-Right/Bottom-Left
Reminder 
MessageOn/Off...

Operation 70
5. 
SYSTEM 
SETUP: 
Advanced
High Altitude 
ModeOn/OffYe s /No
Audio SettingsMuteOn/Off
Volume0~10
Microphone 
Volume0~10
Power On/Off 
Ring ToneOn/Off
Lamp SettingsLamp ModeNormal/Economic/Smart Eco
Reset Lamp 
TimerYe s /No
Equivalent Lamp Hour
Security 
SettingsChange Password
Change Security
Power On LockOn/Off
Web Control 
LockOn/Off
Baud Rate2400/4800/9600/19200/38400/
57600/115200
Test PatternOn/Off
Closed CaptionClosed Caption 
EnableOn/Off
Caption Version CC1/CC2/CC3/CC4
Standby...