BenQ Fp93gwa User Manual

  31   How to adjust your monitor
*DDC/CI, short for Display Data Channel/Command Interface, which was developed by Video Electronics 
Standards Association (VESA). DDC/CI capability allows monitor controls to be sent via the software for 
remote diagnostics.
H. Position Adjusts the horizontal 
position of the OSD menu. 
Press the 
W or X keys to 
change the settings. 0 to 100
V. Position Adjusts the vertical 
position of the OSD menu.0 to 100
Display Time Adjusts the display time of 
the OSD menu.• 5...

32 Troubleshooting  
9. Troubleshooting
Frequently asked questions (FAQ)
The image is blurred:
Read the 
How to adjust the screen resolution on page 18 section, and then select the correct 
resolution, refresh rate and make adjustments based on these instructions.
How do you use a VGA extension cable?
Remove the extension cable for the test. Is the image now in focus? If not, optimize the image by 
working through the instructions in the 
How to adjust the screen refresh rate on page 19 section It 
is...

  33   Troubleshooting
If the LED is illuminated in orange, the power management mode is active. Press any button on 
the computer keyboard or move the mouse. If that does not help, check the signal cable 
connectors. If any pin is bent or broken off, please contact your dealer to get necessary support.
Is the prompt on the display not illuminated at all?
Check the power supply mains socket, the external power supply and the mains switch.
The image is distorted, flashes or flickers:
Read the 
How to...

34  Supported PC Timings  
10. Supported PC Timings
•Image disruption may occur as a result of signal frequency differences from graphic cards 
which do not correspond with the usual standard. This is not, however, an error. You may 
improve this situation by altering an automatic setting or by manually changing the phase 
setting and the pixel frequency from the “DISPLAY” menu.
•To extend the service life of the product, we recommend that you use your computers power 
management function. 
Incoming...

  35   Specifications
11. Specifications
ModelFP93GWa
Display type 
Viewable diagonal 
Native (maximum) resolution
Colors
Contrast / Brightness
Response time
Viewing angle (left/right, up/down) 19.0” wide-screen, active, TFT
480 mm
1,440 x 900
16.2 million
700:1 / 300 cd/m
2
5 ms 
160, 160 (CR>
10)
Line frequency 
Image frequency31 - 83 kHz Multi- frequency monitor
56 - 76 Hz modes within these parameters
Image diagnostics
Controls 
FunctionsAnalog, OSD Technology, i key (automatic image 
setting) 
5...

36 Specifications  
*DDC/CI, short for Display Data Channel/Command Interface, which was developed by Video Electronics 
Standards Association (VESA). DDC/CI capability allows monitor controls to be sent via the software for 
remote diagnostics.