Belkin Router AC750 DB User Manual

							9
GETTING STARTED
Using the WPS Button
1 . Start WPS Push Button Connection (WPS PBC) on your computer or other Wi-Fi device that you would like to connect wirelessly to your Router. Often there will be a button for this purpose in software that came with the device, or a physical “WPS,” “PBC,” or “Security” button on the device itself.
2 . Within two minutes, press the WPS button on your Router and hold for two seconds.
The WPS light (small light above WPS button) will blink blue while it listens for your Wi-Fi device. Once a connection is established, the light will turn blue and then go out. If a connection is not established, the light will blink amber. You may repeat the process to try again.
You can repeat this process for each WPS-enabled device you’d like to add to your network.
When finished installing optional software, click “Thanks, take me to the dashboard.”
Congratulations! You are now at your Router’s dashboard. Your Router is set up and ready to use.  
						

							10
GETTING STARTED
Manually Set Up Your Internet Connection
Use a browser to visit http://router/. You can also try visiting http://192.168.2.1/. The Router’s Welcome page should appear.
Click the “Set it up manually” link. Please select the type of connection your ISP provides. Refer to page 15 for a description of the connection types.
 
If the selected connection type requires additional information (such as an ISP username and password), the system will ask you for it.
At the next screen you will be invited to change your network name and password. Reusing your previous network name (SSID) and password makes connecting your existing devices to the new router much easier.  
						

							11
GETTING STARTED
If you decide to change these settings, then enter the new values and click “Save and Continue.” (Note: The password must be at least 8 characters long.)
If you changed your network name and password, make note of it on the ser vice card located on the foot of the Router. You will then have to connect to the new network. Please refer to page 20 to do this.
Click “Great, what’s next?”  
						

							12
GETTING STARTED
Please take this opportunity to register your Router. This will help technical support if there is a problem with your Router.
Simply complete each of the required fields and click “Complete Registration.” If you don’t want to register right now, click “Register Later” to proceed.
At the next screen you can download optional software that was bundled with your Router.  
						

							13
GETTING STARTED
This screen shows you optional software that is available for your Router, such as the USB software to allow you to print through the Router’s USB port. If you wish to download and install any of these software programs, simply click on the button appropriate for your device.
When finished installing optional software, click “Thanks, take me to the dashboard.”  
						

							14
GETTING STARTED
Congratulations! You are now at your Router’s dashboard. Your Router is now set up and ready to use. 
The status of your Internet connection is shown in the upper left corner of the Router’s homepage.
If it does not say “Online,” troubleshooting information will be displayed.  
						

							15
GETTING STARTED
Manually Configuring Your Router’s Internet from the Dashboard
To set up your ISP connection manually, select “ISP Connection Type” from the list under the header “WAN Settings.”  
						

							16
GETTING STARTED
Dynamic Connection
Cable and fiber customers generally require a dynamic connection. Some DSL customers require a PPPoE connection. Let’s try dynamic first. Select “Dynamic” from the menu that appears and press “Next.”  
						

							17
GETTING STARTED
A host name is generally not required. Hit “Save.” The Router will restart.
If after a few minutes your Internet Status says “Online,” you’re done! You can surf the Internet. 
If these steps do not work, try restarting your modem and repeating the process.
If not, we’ll try a PPPoE connection next.  
						

							18
GETTING STARTED
PPPoE Connection
Some DSL customers require a PPPoE connection. Select PPPoE this time and press “Next.”