BEKO WMB 61421 User Manual

31 - EN
4 Selecting a Program and Operating Your Machine
Control Panel
1	-	Program	selection	knob	(Uppermost	position	
On/Off)
2	-	Program	follow-up	indicator
3	-	Temperature	adjustment	button4	-	Spin	speed	adjustment	button
5	-	Auxiliary	function	buttons
6	-	Time	delaying	button	(in	some	models)
7	-	Start/Pause	button
Turning the machine onPlug	
in	your	 machine.	 Turn	the	tap	 on	completely.	
Check	if	the	hoses	are	connected	tightly.	Place	
the	laundry	in	the	machine.	Add	detergent	and	
softener....

32 - EN
program.	Gentler	washing	movements	and	a	
shorter	washing	cycle	is	used	compared	to	
the	“Cottons”	program.	It	is	recommended	for	
your	synthetic	clothes	(such	as	shirts,	blouses,	
synthetic/cotton	blended	garments,	etc.).	For	
curtains	and	lace,	the	“Synthetic	40”	program	
with	pre-wash	and	anti-creasing	functions	
selected	is	recommended.	Detergent	should	
not	be	put	in	the	pre-wash	compartment.	Less	
detergent	should	be	put	in	the	main	wash	
compartment	as	loose	knit	fabrics	(lace)	foam	
too...

33 - EN
Program selection and consumption table
•	:	Selectable
*	:	Automatically	selected,	not	cancellable.
**:	Energy	Label	program	(EN	60456)
***	If	maximum	spin	speed	of	your	machine	is	lower,	selection	may	be	made	until	maximum	spin	
speed.
C	 Water	consumption,	power	consumption	and	program	duration	may	vary	subject	to	the	changes	in	water	pressure,	water	hardness	and	temperature,	ambient	temperature,	type	and	amount	of	
laundry,	selection	of	auxiliary	functions	and	spin	speed,	and	changes	in...

34 - EN
Auxiliary functionsAuxiliary Function Selection Buttons
Select	the	required	auxiliary	functions	before	
starting	the	program.	Furthermore,	you	may	
also	select	or	cancel	auxiliary	functions	that	are	
suitable	to	the	running	program	without	pressing	
the	"Start/Pause"	button.	To	select	or	cancel	
the	auxiliary	functions,	the	machine	must	be	at	
any	prior	stage	than	the	auxiliary	function	to	be	
selected	or	cancelled.	If	the	auxiliary	function	
cannot	be	selected	or	cancelled,	light	of	the...

35 - EN
selection	process,	the	machine	will	switch	
to	"Stand-by"	mode	and	the	illumination	
level	of	the	temperature,	speed	and	door	
indicators	will	decrease.	Other	lights	and	
indicators	will	turn	off.	In	case	of	turning	
the	program	selection	knob	or	pressing	any	
button,	lights	and	indicators	will	turn	on.
Progress of programProgress	of	a	running	program	is	shown	through	
the	program	follow-up	indicator.	At	the	beginning	
of	every	program	step,	the	relevant	indicator	LED	
will	light	up	and...

36 - EN
5 Maintenance and cleaning
Detergent DrawerRemove	any	powder	residue	buildup	in	the	
drawer.	To	do	this;
1.	 Press	the	dotted	point	on	the	siphon	in	the	softener	compartment	and	pull	towards	you	
until	the	compartment	is	removed	from	the	
machine.
C If	more	than	a	normal	amount	of	water	
and	softener	mixture	starts	to	gather	in	the	
softener	compartment,	the	siphon	must	be	
cleaned.
2.	 Wash	the	dispenser	drawer	and	the	 siphon	with	plenty	of	lukewarm	water	in	a	
washbasin.	
3.	 Replace	the...

37 - EN
by	pulling	out	the	plug	at	the	end	of	the	
hose.	If	the	amount	of	water	to	be	drained	
off	is	greater	than	the	volume	of	the	
container,	replace	the	plug,	pour	the	water	
out,	then	resume	the	draining	process.
•		 After	draining	process	is	completed,	replace	 the	plug	into	the	end	of	the	hose	and	fit	the	
hose	back	into	its	place.
If	 your	 product	 is	not	 supplied	 with	an	emergency	
drain	hose,	do	the	following	as	shown	in	the	
figure	below:
•		 Place	a	large	container	in	front	of	the	filter...

38 - EN
6 Solution suggestions for problems
CauseExplanation / Suggestion
Program	cannot	be	started	or	selected.
•		 Machine	may	have	switched	to	self	
protection	mode	due	to	an	infrastructure	
problem	(such	as	line	voltage,	water	
pressure,	etc.). •		 Reset	your	machine	by	pressing	“Start/Pause/
Cancel”	button	for	3	seconds.	(see,	Canceling	
a	Program)
There	is	water	coming	from	the	bottom	of	the	machine.
•		 There	might	be	problems	with	hoses	or	the	pump	filter. •		 Be	sure	the	seals	of	the	water	inlet...

39 - EN
WMB	61621WMB	61421
6 6
84 84
60 60
50 50
69 69
230	V	/	50Hz 230	V	/	50Hz
10 10
2200 2200
1600 1400
7  Specifications
Specifications	of	this	appliance	may	change	without	notice	to	improve	the	quality	of	the	product.	
Figures	in	this	manual	are	schematic	and	may	not	match	your	product	exactly.
Values	stated	on	the	machine	labels	or	in	the	documentation	accompanying	it	are	obtained	in	
laboratory	in	accordance	with	the	relevant	standards.		Depending	on	operational	and	environmental	
conditions	of...