BEKO WKD 65105 User Manual

WMD 65125
WMD 65105S
WMD 65105
WMD 65085
Washing Machine
Pralka automatyczna
Plně automatická pračka
Automatická pračka
 

2 - EN
1 Warnings
General Safety•  Never place your machine on a carpet covered floor. Otherwise, lack of airflow from below of your machine may cause electrical parts to overheat. This may cause problems with your washing machine.•  If the power cable or mains plug is damaged you must call Authorized Service for repair.•  Fit the drain hose into the discharge housing securely to prevent any water leakage and to allow machine to take in and discharge water as required. It is very important that the...

3 - EN
2 Installation
Removing packaging 
reinforcementTilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon.
Opening the transportation locksA  Transportation safety bolts must be removed before operating the washing machine! Otherwise, the machine will be damaged!1.  Loosen all the bolts with a spanner until they rotate freely (“C”)2.  Remove transportation safety bolts by turning them gently.3.  Fit the covers (supplied in the bag with the...

4 - EN
•   The hose should be pushed into the drainage for more than 15 cm. If it is too long you may have it shortened.•  The maximum length of the combined hoses must not be longer than 3.2 m.
Electrical connectionConnect the machine to an earthed outlet protected by a fuse of suitable capacity.
Important:•   Connection should comply with national regulations.•   The voltage and the allowed fuse protection are specified in the section “Technical Specifications”.•   The specified voltage must be equal...

5 - EN
Turning the machine onPlug in your machine. Turn the tap on completely. Check if the hoses are connected tightly. Place the laundry in the machine. Add detergent and softener. Press the “On/Off” button.
Program selectionSelect the appropriate program from the program table and the following washing temperature table according to type, amount and degree of soiling of the laundry. Select the desired program with the program selection button.
C Programs are limited with the highest spin speed...

6 - EN
• ShirtYou can use this program to wash cottons and synthetics together. There is no need to sort them.
• SportThis program is suitable for clothes that are normally worn for a short time such as sportswear. It is used to quickly wash a small amount of cotton/synthetic blended clothes.
• SuperThis program washes for a longer period at 40°C and gives the same result as the “Cottons 60°C” program, thus it saves energy. It is suitable for clothes for which you cannot use the “Cottons 60°C” program....

7 - EN
Program and consumption table
• : Selectable
* : Automatically selected, not cancellable.
**: Energy Label programme (EN 60456)
Water and power consumption and programme duration may differ from the table shown, subject to changes in water pressure, water hardness and temperature, ambient temperature, type and amount of laundry, selection of auxiliary functions, and fluctuations in the supply voltage.
“Super 40” programme may be selected instead of “Cotton 60*” programme during winter in areas...

8 - EN
Auxiliary functionsAuxiliary Function Selection ButtonsSelect the required auxiliary functions before starting the program.
C Some combinations cannot be selected together. (Ex.: Pre-wash and Quick Wash.Warning signal on the selected auxiliary function will light up.
Auxiliary function selectionIf an auxiliary function that should not be selected together with a previously selected function is chosen, the first selected function will be cancelled and the last auxiliary function selection will...

9 - EN
Changing the selections after the 
program has startedTurning the program knob while the program is in a normal flow will not change the program.
Switching the machine to standby modePress “Start/Pause/Cancel” button momentarily to switch your machine to the standby mode. Auxiliary functions can be cancelled or selected in accordance with the step the program is at. The door can be opened if the water level is suitable. Laundry may be added / taken out by opening the door.
Door lockThe loading...

10 - EN
•  Pull out the pump outlet hose from its housing.•   Place a large container at the end of the hose. Drain the water off into the container by pulling out the plug at the end of the hose. If the amount of water to be drained off is greater than the volume of the container, replace the plug, pour the water out, then resume the draining process.•   After draining process is completed, replace the plug into the end of the hose and fit the hose back into its place.
If your product is not supplied...