Beko Gne 134620 Instruction For Use

EN10
C Adjust the door appropriately as you 
desire by loosing the screws.  
C Fix the door you have adjusted by 
tightening the screws without changing 
the position of the door.  
C Replace the hinge cover and fix with 
the screw.
  

EN11
Installing Water Filter 
(in some models)
Two different water sources may 
be connected to the refrigerator for 
water supply: the mains cold water 
supply and water in a bottle.
Installation Requirements
A pump should be used for bottle water 
usage.
Check that the parts stated below are 
supplied with your appliance.
1. Union for connection of the water 
pipe to the rear of the appliance. (If it 
does not fit, provide it from the nearest 
authorized service.)
2.  2 pieces of pipe clips (In case...

EN12
Connection of Water Hose to 
the Bottle 
(in some models)
To connect water to the refrigerator from 
a bottle, a pump is needed. Follow the 
instructions below after connecting one 
end of the water pipe coming out of the 
pump to the refrigerator as described on 
the previous page.
1. Finish the connection by pushing the 
other end of the water pipe into the 
water pipe inlet of the pump as shown 
in the figure.
2
1a
1b
2.  Put and fix the pump hose into the 
bottle as shown in the figure.
3....

EN13
Connection of the Water 
Pipe to the Cold Water Mains 
Line 
(in some models)
If you want to use your refrigerator by 
connecting it to the cold water mains 
line, 
you will have to connect a standard 1/2" 
valve connection fitting to the cold water 
supply in your house. In case this valve is 
not present or in case you are not sure, 
consult a qualified plumber.
1. Separate the union from the tap 
adaptor. (Figure A) 
2.  Install the tap adaptor to 1/2” valve 
fitting as shown in the figure....

EN14
2. Remove the filter cover in the fridge 
compartment by pulling it forward.
3.  Take out the water filter by-pass cover 
by rotating it downwards. 
A Caution: Make sure that the “Ice off” 
mode is active before taking out the by-
pass cover. 
Note: It is normal that a few drops of 
water drip after the cover has been taken 
out.
4.  Remove the lid on top of the water filter 
to place it as shown in the figure and 
turn upwards to lock it.
5.  Press ice cancel button on the display 
again to exit...

EN15
shown in the figure when it is going to 
be replaced or when it will no longer 
be used and by-pass cover must be 
attached. It must be made sure that Ice 
Off mode is active before taking it out.
A Caution: Water filter cleans some 
foreign particles in the water. It does not 
purify water from microorganisms.
A Caution: Ice Off button must always 
be pressed during replacement of the 
water filter or installing the by-pass 
cover.
Prior to first use of Water 
Dispenser
C Water mains pressure must...

EN16
4  Preparation
C Your refrigerator should be installed at 
least 30 cm away from heat sources 
such as hobs, ovens, central heater 
and stoves and at least 5 cm away 
from electrical ovens and should not be 
located under direct sunlight.
C The ambient temperature of the room 
where you install your refrigerator 
should at least be 10°C. Operating your 
refrigerator under cooler conditions 
than this is not recommended with 
regard to its efficiency.
C Please make sure that the interior of 
your...

EN17
5  Using your refrigerator
Indicator Panel
This touch-control indicator panel allows you to set the temperature without opening 
the door of your refrigerator. Just touch the relevant button with your finger to set the 
temperature. 
1. Eco-Extra / Vacation Button
2. Fast Freeze Button
3. Freezer Compartment Temperature 
Setting Button
4. Fridge Compartment Temperature 
Setting Button
5. Quick Cool Button
6. Multi Zone Compartment 
Temperature Setting Button
7. Vacation Function Indicator
8....

EN18
1. Eco Extra/Vacation Button
Press this button briefly to activate the 
Eco Extra function. Press and hold this 
button for 3 sec. to activate the Vacation 
function. Press this button again to 
deactivate the selected function.
2. Fast Freeze Button
Press this button briefly to activate the 
Fast Freeze function. Press this button 
again to deactivate the selected function.
3. Freezer Compartment 
Temperature Setting Button
Press this button to set the temperature 
of the freezer compartment to -15...

EN19
9. Quick Freeze Function Indicator
It indicates that the Fast Freeze function 
is active. Use this function when 
you place fresh food into the freezer 
compartment or when you need ice. 
When this function is active, your 
refrigerator will run for a certain period of 
time.
Press the relevant button again to 
deactivate this function.
10. Freezer Compartment 
Temperature Indicator
It indicates the temperature set for 
Freezer Compartment.
11. Fridge Compartment 
Temperature Indicator
Indicates the...