Beko 5120 W Manual

WM 5120 W
WM 5120 S
Automatic
washing machine 

Please read this manual first!
Dear Customer,
We hope that your product which has been manufactured in modern faciliti\
es 
and passed through a strict quality control procedure will give you the \
best 
results.
Therefore, we advise you to read through this manual carefully before us\
ing 
your product and keep it for future reference.
This operation manual will… 
…help you use your machine in a fast and safe way.
	 •	Please	read	the	Operation	Manual	before	installing	and	starting	your	machine.
	 •...

EN3
TABLE OF CONTENTS
1  Your Washing Machine 4
Overview	 4
Specifications  5
2  Warnings 6
General Safety  6
First Use  6
Intended use  6
Safety instructions  6
If there are children in your house...  7
Electrical connection  7
3  Installation 9
Removing packaging reinforcement  9
Opening	the	transportation	locks	 9
Appropriate installation location  9
Adjusting the feet  9
Connecting to the water supply.  10
Connecting to the drain  10
Electrical connection   11
Destroying the packaging material  11...

EN4
Top Lid
Detergent Drawer
Control	PanelHeight-adjustable Feet
Door
Filter Cap1
2
3
4
5
6
Overview
1  Your Washing Machine
Figure 1
1
2
3
4
5
6 

EN5
Specifications
Specifications of this appliance may change without notice to improve th\
e quality of 
the product. Figures in this manual are schematic and may not match your\
 product 
exactly. 
Values stated on the machine labels or in the documentation accompanying\
 it are 
obtained in laboratory in accordance with the relevant standards.  Depen\
ding on 
operational and environmental conditions of the appliance, values may va\
ry.Models
Maximum	dry	laundry	capacity	(kg)
Height	(cm)
Width	(cm)...

EN6
Please	read	the	following	information.	
Otherwise,	there	may	be	the	risk	of	
personal injury or material damage. 
Moreover,	any	warranty	and	reliability	
commitment will become void.
General Safety
•	 Never	place	your	machine	on	a	carpet	covered	floor.	Otherwise,	
lack of airflow from below your 
machine may cause electrical 
parts to overheat. This may cause 
problems with your washing 
machine.
•	 If	the	power	cable	or	mains	plug	is	 damaged you must call Authorized 
Service for repair.
•	 Check...

EN7
always be securely fastened and 
remain in an undamaged state.
•	 Fit	the	draining	hose	to	a	washbasin	 or waste system securely before 
starting up your machine. There may 
be a risk of being scalded due to 
high washing temperatures!
•	 Never	open	the	door	or	remove	the	 filter while there is still water in the 
drum.	Otherwise,	there	may	be	the	
risk of flooding and possible injury 
due to the hot water.
•	 Never	force	open	the	locked	door!	 The door will be ready to open just a 
few minutes after...

EN8
cover. In the event of losing the fuse 
cover, the plug must not be used until a 
replacement fuse cover has been fitted. 
Colour of the replacement fuse cover 
must be the same colour as that visible 
on the pin face of the plug. Fuse covers 
are available from any good electrical 
store.
Important
Fitting a different plug
As the colours of the wires in the 
mains lead of this appliance may not 
correspond with the coloured markings 
identifying the terminals on your plug, 
proceed	as	follows:
1...

EN9
Removing packaging 
reinforcement
Tilt the machine to remove the 
packaging reinforcement. Remove the 
packaging reinforcement by pulling the 
ribbon.
Opening the transportation 
locks
C 
Transportation safety bolts must 
be removed before operating the 
washing	machine!	Otherwise,	the	
machine will be damaged!
1.   Loosen all the bolts with a spanner 
until	they	rotate	freely	(“C”)
2.   Remove transportation safety bolts 
by turning them gently. 3.	 Fit	the	covers	(supplied	in	the	bag	
with	the...

EN10
2.  Adjust them until the machine 
stands level and firm.
3.		 Important:	Tighten	all	lock	nuts	up	 again.
Connecting to the water 
supply.
Important:
•		 The	water	supply	pressure	required	to run the machine must be 1-10 
bar	(0,1	–	1	MPa).	(Practically,	it	is	
necessary	to	have	10	–	80	liters	
of water flowing from the tap in 
one minute to have your machine 
run	smoothly.)	Attach	a	pressure-
reducing valve if the water pressure 
is higher.
•		 Connect	the	special	hose	supplied	 with the machine...