Bang & Olufsen Television Beovision 4 User Manual

							BeoVision 4 
Guide  
						

							WARNING: To reduce the risk of fire or 
electric shock, do not expose this 
appliance to rain or moisture. Do not  expose this equipment to dripping or 
splashing and ensure that no objects 
filled with liquids, such as vases, are  placed on the equipment. To completely disconnect this equipment from the AC 
Mains, disconnect the mains plug from 
the wall socket. The disconnect device  shall remain readily operable.
The lightning flash with arrowhead  symbol within an equilateral triangle, is intended to alert the user to the 
presence of uninsulated “dangerous 
voltage” within the product’s  enclosure that may be of sufficient 
magnitude to constitute a risk of  electric shock to persons.
The exclamation point within an  equilateral triangle is intended to alert 
the user to the presence of important  operating and maintenance (servicing) instructions in the literature 
accompanying the product. 
CAUTION: To reduce the risk of 
electric shock, do not remove cover 
(or back).   
No User-serviceable parts inside.  Refer servicing to qualified service personnel.
CAUTIONRISK OF ELECTRIC SHOC K
DO NOT OPEN 
						

							Dear Customer 
This Guide contains information about the daily use of your Bang & Olufsen product. We expect your retailer to deliver, install and set up your product. 
On the Bang & Olufsen website you can find further information about your  product. 
The needs of the user are considered carefully when designing and developing  Bang & Olufsen products. Therefore, please take the time to tell us about your experience with your product. 
To contact us, visit our website on …    www.bang-olufsen.com 
or write to:  Bang & Olufsen a/s  
  BeoCare  
  Peter Bangs Vej 15  
  DK–7600 Struer 
or fax:  Bang & Olufsen  
  BeoCare  
  +45 9785 3911 (fax) 
Technical specifications, features and the use 
thereof are subject to change without notice.  
3510313 0902 
3 
						

							Motorised stand 
You can make different settings for your T V, such as favourite viewing and listening positions if your T V is equipped with an optional motorised stand. During first-time 
setup you are prompted to calibrate your stand. 
Calibrate the stand 
During first-time setup, the STAND ADJUSTMENT  menu appears. The motorised movement of the 
T V will not work until the calibration process  has been completed. 
Positions of the TV 
Programme a position for when you watch T V, listen to music, and when the T V is switched 
of f. 
Information 
Stand adjustment1*First-time setup 
Remote control Set the maximum angle the T V will turn – left and right. 
During first-time setup, when you have calibrated the stand and set the T V positions, press the green button to continue first-time setup. 
The instructions in this Guide are based on the Beo5 remote control, but you can also  operate the T V with Beo4.  NOTE! For general information on daily 
operation, see the BeoSystem Guide 
enclosed with your T V. 
At SET LEFTMOST POSITION 
turn left to the point you wish 
to restrict the movement to 
At SET TOP POSITION tilt up  to the point you wish to restrict the movement to  At SET RIGHTMOST POSITION 
turn right to the point you wish 
to restrict the movement to 
At SET BOT TOM POSITION  tilt down to the point you wish 
to restrict the movement to  Accept*
1
Accept*1 
Select VIDEO, AUDIO or 
STANDBY 
Turn/tilt T V as desired 
ST
AND POSITIONS
VIDEO
A UDIO
ST ANDBY
ST AND  ADJUSTMENT
 
  selectSTAND  ADJUSTMENT
SET LEFTMOST POSITION
SET RIGHTMOST POSITION
SET  TOP POSITION
SET BO TTOM POSITION
turn  turn
  next
STAND ADJUSTMENT 
STAND POSITIONS 
4   
						

							Turn/tilt the TV On/off positions 
You can turn or tilt your T V without storing the  position. 
When the T V is switched to standby, the loud -
speaker retracts and the screen moves down. 
When the T V is switched on, the screen moves up  and the loudspeaker will appear below the screen.  Auto stop: For your safety, the built-in automatic 
sensors will make the screen and loud  
speaker stop 
if anything obstruct their movement. Remove the  object and press • to continue switching the T V 
on or off. 
or
Press  Press Turn T V  Select position*2 
2*TV positions
Visit the Bang & Olufsen website  ‘Position 1’ is the far left position and ‘Position 9’ is the far right.
For more information about your television, visit our website: www.bang-olufsen.com  Tilt T V 
StandPosition 1…9  Turn 
5 
						

							Automatic calibration  
Approximately for every 100 hours of use, the 
T V will initiate a calibration automatically, when  you press the standby button. 
Manual calibration  
The T V must be switched on for more than two  minutes and be in T V mode for the AUTO 
COLOUR MANAGEMENT menu to be available.   We recommend that you let the T V perform calibration automatically instead of manually 
Information 
1*Manual calibration  
Calibration failed    
Auto Colour Management ensures perfect colours on the screen continuosly. During calibration, a sensor arm swings down from the T V frame and an on-screen bar changes between various greyscale colours. 
After manual calibration Sensor arm retracts and T V returns to last chosen  source  CALIBRATION COMPLETE shortly appears on 
screen 
Bring up T V SETUP 
menu  Select OPTIONS 
menu  Activate AUTO 
COLOUR MANAGEMENT  Calibration process 
begins*
1 
Calibrate colour accuracy of the screen 
All text is removed from the screen, the sensor arm swings down and the 
calibration starts. 
If the sensor arm does not swing down fully, the calibration is not performed 
and the arm is retracted if needed. If the calibration was initiated automatically, 
the T V will attempt to execute the calibration the next time it is switched off.    NOTE! Never switch off your system or 
disconnect it from the mains during calibration. 
6 
						

							We expect your retailer to deliver, install and set up your product. However, regular maintenance, such as cleaning, is the responsibility of the user. To achieve the best 
result, follow the instructions below. 
Maintenance 
Cleaning instructions
Cautions 
7
Cabinet surfaces Wipe dust off the surfaces using a dry, soft cloth. Remove grease stains or persistent dirt with a soft, lint-free, firmly wrung cloth, dipped in a 
solution of water containing only a few drops of  mild detergent, such as washing-up liquid. Never 
use alcohol or other solvents to clean any parts of 
the T V.  Plasma screen 
Use a soft, dry cloth to wipe dust off the screen. Do not use liquid cleaners or aerosol cleaners. 
The screen is developed for indoor use in dry,  domestic environments only, and for use within a 
temperature range of 10 – 40°C (50 –105°F). 
The picture can be distorted at altitudes where  the air pressure is lower than 833 hPa (approximately 1500 m (5000 feet) or higher. 
Do not place any items on top of the screen. 
Due to the heavy weight of the screen, do not try 
to lift it yourself. Leave such operations to  qualified personnel. 
The screen is not designed to stand on its own. It  must be supported until mounted on a wall bracket or stand. To prevent injury, use Bang & 
Olufsen approved stands or wall brackets only! 
When mounting the screen in a wall bracket,  leave a space of at least 10 cm (4”) at the top, 
bottom and sides. Do not cover the ventilation 
holes on the rear, as this may cause the screen to  overheat.  Do not attempt to open the screen. Leave such 
operations to qualified service personnel! 
Avoid placing the product in direct sunlight or  direct artificial light, such as a spotlight. 
Do not connect any of the products in your 
system to the mains, until you have connected all 
the cables. 
Do not leave the screen in contact with articles containing rubber or PVC for long periods of 
time. 
Do not allow still pictures to be displayed on the 
screen for an extended period of time, as this can  cause a permanent after-image to remain on the 
screen. 
The system can only be switched off completely  by disconnecting it from the wall socket.  
						

							For the US-market only! NOTE: This equipment has been tested and found 
to comply with the limits for a class B digital  device, pursuant to part 15 of the FCC Rules. 
These limits are designed to provide reasonable  protection against harm  
ful inter 
ference in a 
residential   installation. This equipment generates, 
uses and can radiate radio frequency energy and, 
if not installed and used in   accordance with the 
instructions, may cause harmful interference to  radio communications. However, there is no 
guarantee that interference will not occur in a  particular installation. If this equipment does 
cause harmful interference to radio or tele  
vision 
reception, which can be determined by turning 
the equip  
ment off and on, the user is   encouraged 
to try to correct the   interference by one or more 
of the following measures: 
–  Reorient or relocate the receiving antenna. 
–  Increase the separation between the equipment 
and receiver.
–  Connect the equipment into an outlet on a 
circuit different from that to which the receiver 
is connected. 
–  Consult the retailer or an experienced radio/ T V 
technician for help. 
For the Canadian market only! 
This class B digital apparatus meets all require  
ments 
of the Canadian Interference-Causing Equipment 
Regulations.  This product is in conformity with the 
provisions of the Directives 2004/108/
EC and 2006/95/EC. 
Electrical and electronic equipment, parts and 
batteries marked with this symbol must not be disposed of with normal household wastage; all 
electrical and electronic equipment, parts and  batteries must be collected and disposed of 
s eparately. 
When disposing of electrical and electronic  equipment and batteries by use of the collection 
systems available in your country, you protect the  environment, human health and contribute to the prudent and rational use of natural resources. 
Collecting electrical and electronic equipment,  batteries and waste prevents the potential  contamination of nature with the hazardous 
substances which may be present in electrical  
and electronic products and equipment.
Your Bang & Olufsen retailer will advise you of the  correct way of disposal in your country. 
If a product is too small to be marked with the  symbol, it will appear in the User Guide, on the 
Guarantee certificate, or on the packaging. 
Waste Electrical and Electronic Equipment 
(WEEE) – Environmental protection 
Manufactured under license from Dolby Laboratories. Dolby, Pro Logic, and the 
double-D symbol are registered trademarks of  Dolby Laboratories. 
Confidential unpublished works. 
Copyright 1992–2003 Dolby Laboratories.  All rights reserved. 
Manufactured under license under 
U.S.  Patent  #’s: 5,451,942; 5,956,674; 5,974,380; 
5,978,762; 6,487,535; 7,003,467; 7,212,872 &  other U.S. and worldwide patents issued &  pending. 
DTS, DTS Digital Surround, ES, and Neo:6 are 
registered trademarks and the DTS logos, and  Symbol are trademarks of DTS, Inc.  © 1996 -2008 DTS, Inc. All Rights Reserved. 
8 
						

							9