ATT 3800hgvb Manual

Access the Management and Diagnostic Console
59
Advanced - Provisioning Info Page
The Advanced – Provisioning Info page displays the parameters with which the 2Wire gateway was 
provisioned. 

Access the Management and Diagnostic Console
60
Advanced - Configure Time Ser vices Page
The Advanced – Configure Time Ser vices page allows you to view and change system time and date 
settings.
As part of the 2Wire gateway setup process, users spec ify the time zone in which they are located so that 
the time and date are automatically displayed in the 2Wir e gateway user interface. These time settings are 
displayed in the Current Time Settings panel, which s hows the current date, time, time zone,...

Access the Management and Diagnostic Console
61
Advanced - Configure Ser vices Page
The Advanced – Configure Ser vices page allows users to change the timeout settings for NAT, enable 
broadband status notification, enable the SIP ALG,  and change the upstream maximum transmission rate. 

Access the Management and Diagnostic Console
62
Advanced - DNS Resolve Page
The Advanced - DNS Resolve page allows users to name network devices (such as printers or web ser vers) 
so that they can be easily accessed by other users on the network. 

Access the Management and Diagnostic Console
63
Advanced - Link Manager States Page
The Advanced – Link Manager States page is a tree representation of the 2Wire gateway interface stack, 
and shows the internal state of the 2Wire gateway.
The Link Manager States page is  used to gather dynamic information on internal networking modules, and 
is based on the runtime configuration of the 2Wire ga teway. The information cannot be used to configure 
the 2Wire gateway.
To view information about each node,...

Access the Management and Diagnostic Console
64
Advanced - Detailed Log Page
The Advanced – Detailed Log page is a debug log facility modeled after syslog, and provides advanced 
diagnostic capabilities. 

65
Upgrade the Software
Gateway field upgrades are typically performed via CMS, which is the gateway remote management system. 
The following procedure describes how to perfor m a local upgrade; however, because the gateway’s 
configuration information is not retained when perf orming a local upgrade, upgrading via CMS is the 
preferred method. Perform the local upgrade  only if you cannot access the broadband link to upgrade via 
CMS, or the target release is not published on CMS.
Note: This procedure...

Upgrade the Software
66
4.After the gateway reboots, the Conexant firmware is upgraded. 

67
Configuring Multiple Static IP Addresses
This chapter describes how to configure the 3700HGV-B for use with multiple service provider-assigned 
(static) broadband IP addresses on the SBC Lightspeed network.
To use multiple broadband addresses with the 3700HGV-B , you must have subscribed to the appropriate 
ser vice from your Internet Service Provider. In  addition, you need the IP address and networking information 
that has been identified for the subscribed service.
The configuration process is...

Configuring Mulitple Static IP Addresses
68
Step 1: Enable Public Network Mode
To enable Public Network mode:
1.Access the Management and Diagnostic Console (MDC) by entering 
http://gateway.2wire.net/management  in your browser’s address bar. 
2.In the left-hand navigation menu, click the Local Network - Configure link. 
The Local Network - Configuration page opens. 
3.In the Public Network pane, click the Create a route from the Internet to the public network specified below 
checkbox. Althernatively,...