Asus Z500a Service Guide
Here you can view all the pages of manual Asus Z500a Service Guide. The Asus manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 1
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- - 1
1 1 1
Chapter
Disassembly Procedure
Please follow the information provided in this section to perform
the complete disassembly procedure of the notebook. Be sure
to use proper tools described before.
500A Series Notebook consists of various modules. This chapter describes
the procedures for the complete notebook disassembly. In addition, in
between procedures, the detailed disassembly procedure of individual
modules will be provided for...
Page 2
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- -
2
22 2
Batter y module
The illustration below shows how to remove the battery module.
1. Turn the notebook over. Unlock one latch (no.1) and remove the battery pack
from bottom side (no.2).
Removing ROM driver
1. Unlock ODD button and separate optical device from base unit.
BATTERY
2
1
2
ROM DRIVER
REMOVAL
1
Page 3
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- -
3
33 3
HDD Module
The illustrations below show how to remove the HDD module from the notebook.
Removing HDD Module
1. Release 2 screws (no.1 M2.5x4.0) from bottom of notebook.
2. Pull out the HDD module from front side of notebook. (no.2).
Disassembling HDD Module
1. Remove 2 screws (no.1 M3*0.5 + 3.5I (K) B-NI) on both side of the HDD module.
Please do not touch inside of the HDD module.
The below illustration is...
Page 4
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- -
4
44 4
Memor y Module
The illustrations below show how to remove the Memory module from the notebook.
The Z500A Series Notebook comes standard without memory onboard. There are
two expansion SODIMM sockets for you to upgrade the total memory up to 2GB
with two 1024 MB modules.
Removing Memory module
1. Remove two screws (no1; M2.5x4 B) to take off RAM door from bottom side.
2. If there is an existing memory, remove it by opening the...
Page 5
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- -
5
55 5
Keyboard Module
The illustration below shows how to remove the K/B cover and keyboard plate.
Removing K/B cover
1. Release two screws (no1,2; M2x4) from K/B cover on left and right side.
2. Press the “Numlk” key to pry the keyboard cover (no.1) open then slide right it
to separate top cover module.
3. Remove 2 screws (no.1; M2.5x8) on the back of Notebook.
K/B COVER
REMOVAL
K/B MODULE
12
1
Page 6
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- -
6
66 6
4. Remove 2 screws (no.1,2; M2.5x4.0) to separate keyboard module.
Removing Keyboard Cable
1. Use a flexible connector tool to unlock the cable connector on both ends (no. 1).
2. Carefully pull out the keyboard cable (no. 2) with a pair or tweezers.
3. Lock the connector (no. 3) again to avoid possible breakage.
4. Finally the keyboard plate can be removed from the notebook.
CABLE
REMOVAL
1 2
1. Unlock
2. Cable...
Page 7
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- -
7
77 7
CPU Module
The illustrations below show how to remove the CPU module from the notebook.
The module contains CPU, CPU thermal pad, and CPU thermal module.
Removing CPU
1. Remove 3 screws (no.1~4;M2x9.0 spring screw) to unlock CPU FAN. And
disconnect the CPU FAN cable (no.4).
2. Using one-slot screwdriver to turn right direction to loosen the CPU socket.
3. Use the CPU vacuum to “suck...
Page 8
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- -
8
88 8
LCD module
The illustrations below show how to remove and disassemble the LCD module. The
module contains LCD panel, inverter board, LCD hinge bracket, hinge cover, LCD
bezel and LCD cover.
Removing LCD Module
1. Remove totally 4 screws (M2.5x8) then take away 2 wireless antennas on both
sides.
2. Disconnect the LCD cable (no. 2) from the motherboard.
3. Lift straight up the LCD module to separate from the...
Page 9
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- -
9
99 9
Disassembling LCD Module
1. Remove 4 rubber pads & screws from the LCD module (no1; M2.5x4.0).
2. Carefully pry the inside edges of the LCD case open on all four edges with your
fingers. Then, lift the LCD bezel away from the LCD module.
3. Remove 8 screws (no.1; M2x3.0) to separate the LCD both side Hinge from LCD
panel and 6 screws (no2; M2.5x4.0;) on both side hinges then take hinges away
from LCD module.
4....
Page 10
DISASSEMBLY PROCEDURE
2
2 2 2 -
-- -
10
1010 10
Top cover Module
The illustrations below show how to disassemble and remove the top cover module of
the notebook. The module contains the top cover itself and touch pad module.
Removing Top cover Module
1. Remove 7 screws (no.1; M2.5x6.0) on front bottom side of notebook.
2. Remove 2 screws (no.2; M2.5x6.0) on right side of notebook
3. Remove 6 screws (no.3; M2.5x6.0) on rear bottom side of notebook.
4. Remove 2 screws (no.4;...