Apple power mac g4 quicksilver User Manual
Have a look at the manual Apple power mac g4 quicksilver User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Take ApartVideo Card - 9 Replacement Note: If the replacement card does not have a fence already installed, attach the fence enclosed in the box. Using a Phillips screwdriver, install the two small Phillips screws on either side of the ADC connector and the two large Phillips screws on the fence side tabs. Using pliers, install the two jack-nut screws on either side of the VGA connector.
Take ApartModem, AGP Graphics/Gigabit Ethernet/Digital Audio/QuickSilvers - 10 Modem, AGP Graphics/Gigabit Ethernet/Digital Audio/ QuickSilvers Note: The Power Mac G4 (AGP Graphics/Gigabit Ethernet/Digital Audio/ QuickSilver/QuickSilver 2002) modem requires a modem filter; the two are separate parts. To remove the modem, you do not need to remove the modem filter. Before you begin, open the side access panel.
Take ApartModem, AGP Graphics/Gigabit Ethernet/Digital Audio/QuickSilvers - 11 Warning: Use care when disconnecting or connecting the modem to the J27 connector on the logic board. Bent pins in the J27 connector could cause a short in the logic board. 1 . Remove the two modem mounting screws. 2. Lift the modem straight up to disconnect it from the logic board.
Take ApartModem, AGP Graphics/Gigabit Ethernet/Digital Audio/QuickSilvers - 12 3. Disconnect the modem filter cable from the modem. 4. Remove the modem from the computer. Replacement Note: After replacing an international modem, use the Modem Country Selector utility to set the modem to the correct country.
Take ApartModem Filter, AGP Graphics/Gigabit Ethernet/Digital Audio/QuickSilvers Modem Filter, AGP Graphics/Gigabit Ethernet/Digital Audio/ QuickSilvers Before you begin, do the following: ¥ Open the side access panel. ¥ Remove the logic board.
Take ApartModem Filter, AGP Graphics/Gigabit Ethernet/Digital Audio/QuickSilvers 1. Remove the screw that secures the modem filter to the I/O panel.
Take ApartModem Filter, AGP Graphics/Gigabit Ethernet/Digital Audio/QuickSilvers 2. Free the modem filter cable from the chassis guides and remove the modem filter from the computer.
Take ApartModem, PCI Graphics - 16 Modem, PCI Graphics Before you begin, open the side access panel. Warning: Use care when disconnecting or connecting the modem to the J27 connector on the logic board. Bent pins in the J27 connector could cause a short in the logic board.
Take ApartModem, PCI Graphics - 17 1. Remove the screw (located next to the modem port) that secures the modem to the I/O panel. 2. Remove the screw that secures the modem leg standoff to the logic board.
Take ApartModem, PCI Graphics - 18 3. Carefully disconnect the flexible modem cable from the logic board. Important: The modem cable is very fragile. 4. Gently lift up the modem to remove it from the logic board. Note: If you are replacing the modem, continue with the Take Apart procedures to remove the modem from the bottom modem shield.