Apple power mac g4 quicksilver User Manual
Have a look at the manual Apple power mac g4 quicksilver User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Take Apart Rear Vented Panel - 159 1. Open the side access panel. 2. Remove the three 2.5 mm Allen screws. 3. Push in on the six tabs to release the panel from the chassis.
Take Apart Rear Vented Panel - 160 4. Once the tabs are released, carefully pull the rear panel forward to remove.
Take ApartLatch Panel - 161 Latch Panel Before you begin, remove the following: ¥ video card ¥ PCI cards (if present) ¥ Power Mac G4 (PCI Graphics): FireWire board (if present) ¥ Power Mac G4 (PCI Graphics): modem (if present) ¥ AirPort card (if present) ¥ logic board
Take ApartLatch Panel - 162 1. Remove the four Phillips screws holding the panel to the chassis. 2. Slide the panel toward the hard drives, freeing the latch panel from the tabs on the chassis. Note: Circles indicate tab locations. 3. Remove the latch panel.
Take Apart Right Side Access Panel - 163 Right Side Access Panel Before you begin, remove the following: ¥ PCI cards (if present) ¥ video card ¥ FireWire board (if present) ¥ modem (if present) ¥ AirPort card (if present) ¥ logic board
Take Apart Right Side Access Panel - 164 1. Remove the four 2.5 mm Allen screws on the side panel.
Take Apart Right Side Access Panel - 165 2. Open the side access panel. 3. Remove the two Phillips screws attaching the right side panel to the metal chassis.
Take Apart Right Side Access Panel - 166 4. Using a flatblade screwdriver or needlenose pliers, push or squeeze the plastic tabs (protruding through the side chassis panel), to release the right panel from the metal chassis. 5. Remove the right side panel from the chassis.
Take ApartLeft Side Panel - 167 Left Side Panel No preliminary steps are required before you begin this procedure.
Take ApartLeft Side Panel - 168 1. Remove the four 2.5 mm Allen screws on the side panel.