Apple power mac g4 quicksilver 2002 User Manual
Have a look at the manual Apple power mac g4 quicksilver 2002 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Take ApartCD/DVD Drive, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio - 99 3. Disconnect the following cables from the back of the CD-ROM, DVD-ROM, or DVD-RAM drive: ¥power cable (P7) ¥IDE data cable ¥Power Mac G4 (PCI Graphics): audio cable 4. If shielding tape connects the ribbon cable and the carrier, detach the tape from the carrier. 5. Disconnect the following cables from the back of the Zip drive: ¥power cable (P6) ¥IDE data cable
Take ApartCD/DVD Drive, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio - 100 6. Continue sliding the drive carrier out of the computer. Important: The drive carrier may be difficult to push forward due to the EMI gasket and tape located on the underside of the carrier (directly below the Zip drive). 7. When the carrier is out of the computer, remove the EMI shield from the back of the CD-ROM, DVD-ROM, or DVD-RAM drive.
Take ApartCD/DVD Drive, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio - 101 Note: Perform the following procedure if you are replacing the CD-ROM, DVD-ROM, DVD-RAM, or Zip drive. 8. Using a Phillips screwdriver, remove the drive carrier mounting screws. 9. Slide the drive(s) out of the carrier. Replacement Note: The DVD-RAM drive is not as tall as the CD-ROM and DVD-ROM drives. Before screwing the DVD-RAM
Take ApartCD/DVD Drive, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio - 102 drive back into the carrier, lift the back of the drive slightly so that the drive is flush against the carrier. Replacement Note: When inserting the drive carrier into the computer, make sure the carrier tab slides into the hole on the stationary drive shelf.
Take ApartZip Drive, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio - 103 Zip Drive, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio If removing the Zip drive, follow the procedures for removing the CD/DVD Drive. Important: After you remove the screws mounting the Zip/CD/DVD carrier to the chassis, the carrier may be difficult to push forward due to EMI tape on the carrierÕs underside holding it in place. Continue pushing forward until the carrier is released.
Take ApartFan, Power Mac G4 (QuickSilvers) - 104 Fan, Power Mac G4 (QuickSilvers) Before you begin, open the side access panel.
Take ApartFan, Power Mac G4 (QuickSilvers) - 105 1. Press the small locking tab on the power-to-fan cable connector and disconnect the cable.
Take ApartFan, Power Mac G4 (QuickSilvers) - 106 2. Remove the two screws that mount the fan bracket to the chassis. Replacement Note: Use the longer of the two screws to secure the cable holder and the fan bracket. 3. Lift the fan bracket out of the computer.
Take ApartFan, Power Mac G4 (QuickSilvers) - 107 Perform the following procedure only if you are replacing the fan. 4. Using a Phillips screwdriver, remove the four screws securing the fan to the fan bracket. 5. Lift the fan from the fan bracket.
Take ApartFan, Power Mac G4 (QuickSilvers) - 108 Replacement Note: When replacing the fan in the bracket, make sure the arrows on the side of the fan point away from the bracket.