Apple imac usb 2 0 User Manual
Here you can view all the pages of manual Apple imac usb 2 0 User Manual. The Apple manuals for Display are available online for free. You can easily download all the documents as PDF.
Page 111
102 - iMac (USB 2.0) Take Apart Display, 15" Flat Panel Display, 15 Flat Panel Tools This procedure requires the following tools: • 1.5 mm hex tool • Plastic stylus to lift the panel Part Location Preliminary Steps Before you begin, do the following: • Position the computer in the service stand.
Page 112
iMac (USB 2.0) Take Apart - 103 Display, 15" Flat Panel Procedure 1. Remove ten screws connecting the back cover to the flat panel LCD display. 2. It is not necessary to remove the two screws circled below unless you are removing the neck or the panel shield.
Page 113
104 - iMac (USB 2.0) Take Apart Display, 15" Flat Panel 3. With a plastic tool, raise the display to access cables underneath the flat panel. 4. Disconnect the inverter cable shown below.
Page 114
iMac (USB 2.0) Take Apart - 105 Display, 15" Flat Panel 5. Raise the display to disconnect the circled items: The inverter cable, the microphone, and the power-on LED.
Page 115
106 - iMac (USB 2.0) Take Apart Display, 15" Flat Panel 6. This shows a close up of the video cable, ferrite bead, and video cable clip. After removing the kapton tape, carefully use a screwdriver to pry the ferrite bead from the video cable clip. Pry the ferrite bead from the side or from the back. Note: The ferrite bead is fragile and could break if a screwdriver is placed in the middle of the ferrite bead and is used as leverage to remove the bead. 7. Peel the black tape back to expose...
Page 116
iMac (USB 2.0) Take Apart - 107 Display, 15" Flat Panel 8. After disconnecting all the cables, you are left with the 15" LCD flat panel service part (661-2582).
Page 117
108 - iMac (USB 2.0) Take Apart Inverter, 20" Display Inverter, 20 Display Tools • Torx-10 screwdriver Part Location Preliminary Steps Before you begin, do the following: • Position the computer in the service stand. • Lift the flat panel to access the inverter.
Page 118
iMac (USB 2.0) Take Apart - 109 Inverter, 20" Display Procedure 1. Carefully raise the display and disconnect the inverter cables. 2. Remove the four inverter screws (circled below) and disconnect the inverter cable on the left side of the board. 3. Lift the inverter board off the rear housing.
Page 119
110 - iMac (USB 2.0) Take Apart Inverter, 17" Display Inverter, 17 Display Tools Torx-10 screwdriver. Part Location Preliminary Steps Before you begin, do the following: • Position the computer in the service stand. • Remove the flat panel display.
Page 120
iMac (USB 2.0) Take Apart - 111 Inverter, 17" Display Procedure 1. Remove the four panel screws (circled below) to access the inverter on the left side of the panel. 2. Remove the kapton tape holding the cables in place.