Anschutz LaserPower II Laser Rifle User Manual

If.t\fe.biat\flon.target.is.not.to.be.used.for.long..
periods,.t\fe.batteries.must.be.removed.to.prevent.
damage.due.to.leakage.or.corrosion.
No Te!
T\fe.life.of.t\fe.batteries.in.t\fe.biat\flon.target. .
depends.on.t\fe.frequency.of.use..Wit\f.frequent.use,.
it.is.entirely.possible.for.t\fe.batteries.to.be.drained.
wit\fin.1-2.days..A.low.batter y.c\farge.condition.
in.t\fe.biat\flon.target.is.indicated.by.a."LO".in.t\fe.
display.
No Te!
Only.batteries.of.t\fe.same.brand.and.t\fe.same. ....

Safety instructions:
To \faintain the technically perfect condition of the unit and to guaran-
tee safe operation, you \fust always observe the safety instructions and 
warnings.
•  Ask an expert if you are not clear about the function, safety or con-
nection of the unit.
• Store away fro\f access by children!
• Keep s\fall parts etc. away fro\f children and pets.
•   In co\f\fercial buildings, co\f\fply with the accident prevention stipu-
lations for electrical equip\fent and devices of the relevant...

7.3	remote	control		
	
	
	
	
	
Two Cr 2016 button cells [20] are required for the remote   
control unit.
Fig.9 Button \bells
 
X Open the battery compartment cover (on the rear side of the 
remote controller) with a suitable tool.
Fig.10 Opening the\s battery \bompartment
 
9 The battery compartment is now open.  
X remove the Cr 2016 button cells [20] from the remote   
control unit [21] (see arrow).
Fig.11 Battery \bompartment open
 
X replace the batteries (the "+" terminals must face...

14
8	Shooting	
 
X switch the biathlon target on (On/Off switch [14] to "I").
[14]
Fig. 13 Swit\bhing o\sn the biathlon tar\sget
 
X Press the loading button [1] on the l aserPower II rifle,  
aim and pull the trigger [7].
Fig.14 Loading and \sshooting
 
9 Hits are displayed by a green light signal on the biathlon 
target.
[1]
[7]
The hits display is reset using the remote control [21]. 
X Point the remote control [21] at the biathlon target and   
press the button.
 
9 The biathlon target is...

8.2	releasing	the	safety	on	the	LaserPower	II	rifle	
The safety on the l aserPower II rifle is released when the safety 
catch (where present) is in the forward position (direction of   
arrow).
Fig.16 Trigger safety
8.3	 Target	reducer	
The target reducer [17] and the biathlon target [10] are provided 
with Velcro pads.  
X To fasten the target reducer [17] to the biathlon target [10], 
press the reducer [17] on to the target [10] using light pres -
sure (the attachment points on the two components must...

8.5	rear	sight	adjustment	
The ansCHÜTZ l aserPower II rear sight can be adjusted both 
vertically and horizontally.
sighting in: The target point always responds to the setting of the 
rear sight [2]. Moving the rear sight [2] to the right causes the 
shot to be displaced to the right. Moving the sight upwards causes 
the shot to be displaced upwards.
Fig.17 Rear sight
 
X To access the adjusting screws, unscrew the aperture [x].
Fig.18 Removing th\se aperture
 
X For vertical adjustment, loosen screw...

9	Maintenance	 /	cleaning
$
$ The$inside$of$the$\barrel$of$the$LaserPo\fer$II$rifle$must$al\fays$\be$kept$free$of$dirt,$
dust,$sno\f,$etc.
$
$ A$soft,$dry$cloth$must$\be$used$to$clean$the$LaserPo\fer$II$Set.
$
$ For$stu\b\born$dirt,$the$cloth$can$\be$moistened$slightly$and$soaked$\fith$a$mild$$
cleaning$agent.
$
$ Dry$the$LaserPo\fer$II Set$\fith$a$soft$cloth.
P\fysical.damage!
Damage to the product caused by chemicals.
 
h no abrasives, scouring pads, alcohol, paint 
thinners, petrol or cloths that have...

ANSCHÜTZ.does.not.itself.market.any.software,..
nor.does.it.offer.any.software.support.
No Te!
Up.to.99.biat\flon.targets.can.be.interconnected. .
over.t\fe.RS-485.interface.[12].and.evaluated..
using.appropriate.software.(competition.mode).. .
T\fe.targets.are.automatically.configured.wit\f. .
a.unique.consecutive.target.number,.w\fic\f.is..
indicated.in.t\fe.information.display.[11].
.
It.is.also.possible.to.supply.power.to.several. .
biat\flon.targets.via.t\fe.RS-485.cable.[18].w\fen. ....

12	Troubleshooting
FaultPossible causeRemedy
Rifle:
No laser spot Batteries too low Replace batteries
Laser actuator defective Send for repair
Laser not exactly on target Laser not aligned correctly Send for alignment
Trigger does not release Trigger not cocked Cock the LaserPower
Trigger safety engaged Release trigger safety
B
iathlon target:
Laser hits but target does not 
light up Target not switched on Switch on target
"LO" (Low battery) appears in 
display Replace batteries
Batteries are...

20
14	Miscellaneous
additional information is available on the Internet at   
www.anschuetz-sport.com.
ansCHÜTZ provides news on this product and other products  
in the ansCHÜTZ newsletter, which you can sign up to for free 
on the Internet.
www.anschuetz-sport.com
15	Guarantee
< < <   W A R R A N T Y   > > >
1. \faterial: This product has been released for sale after the product itself, its \faterials and individual co\fponents have been subjected to strict inspection, or the rifl e has de\fonstrated...