Home > Anaheim > Stepper > Anaheim Stepper TM2000 Users Guide

Anaheim Stepper TM2000 Users Guide

Add to Favourites
    Download as PDF

    View the Anaheim Stepper TM2000 Users Guide for free. All the Anaheim manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 TM2000 UNIVERSAL OSCILLATOR USERS MANUAL Jul 8, 2002#L010107COPYRIGHT Copyright 1994 by Anaheim Automation. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual, or otherwise, without the prior written permission of Anaheim Automation, 910 E. Orangefair Lane, Anaheim, CA 92801. DISCLAIMER Though every effort...
    Page 2 ACCEL/DECEL SLOWFASTJOYSTICK GAIN MIN MAX BASE1BASE2 MAX1MAX2 R1R2 R3R4R5R6FIGURE 1: DIMENSIONS AND COMPONENT LOCATIONS OF TM2000. AND DIMENSIONS OF TRACK. DESCRIPTIONThe TM2000 UNIVERSAL OSCILLATOR is a linear ramping pulse generator and JoystickThere are basically eight inputs which can determine the output pulse rate. Three select lines Controller with several options. It is designed to be used with Anaheim Automation StepS1, S2, S3 (pins 1,2,3 on TB1) determine which of the eight inputs is...
    Page 3 FIGURE 2: VOLTAGE IN (VCO INPUTS) VS. FREQUENCY OUT (UNDIVIDED). Some applications may require ramping up only and no ramping down. This is the third+/- VCO INPUTmode. To operate in this mode, the STOP/RUN input and the S1 input are tied together.Refer to the Table 1 for proper control input settings. This input is similar to the +VCO input When both inputs are pulled low, the pulse generator starts running at BASE speed andexcept it automatically produces the DIRECTION and STOP/RUN signals....
    Page 4 ACCELERATION/DECELERATION RAMPINGsame. The minimum pulse rates for the +/- VCO Input and the JOYSTICK Control are roughlyThe acceleration and deceleration of the TM2000 are linear and adjustable (by R1) fromten times higher than the minimum speeds in Table 2 (The MAX rates are the same as in approximately 2,700,000 steps/sec to 61,000,000 steps/sec. Remember if you are using aTable 2). 2 2 divided output, also divide these accel/decel rates by the same divisor to get a corresponding number. For...
    Start reading Anaheim Stepper TM2000 Users Guide

    Related Manuals for Anaheim Stepper TM2000 Users Guide

    All Anaheim manuals