Home > Anaheim > Brushless DC > Anaheim Brushless DC MDC151012301Brushless DC Driver Users Guide

Anaheim Brushless DC MDC151012301Brushless DC Driver Users Guide

Add to Favourites
    Download as PDF

    View the Anaheim Brushless DC MDC151012301Brushless DC Driver Users Guide for free. All the Anaheim manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 September 2012 L0104051 MDC151-012301 Series 12V, 30A Brushless DC Controller User’s Guide 910 East Orangefair Lane, Anaheim, CA 92801 e-mail: info@anaheimautomation.com(714) 992-6990 fax: (714) 992-0471 website: www.anaheimautomation.com ANAHEIM AUTOMATION
    Page 2 September 2012 L0104052 MDC151-012301 Driver Features • Maximum Current Limit Setting from 10.0-30.0 Amps (peak) • Internal or External Potentiometer Speed Control • 0V to 5V External Voltage Speed Control • 2-Quadrant Operation • Hall Sensor Feedback • Constant Velocity Mode • Short Circuit Protection • Requires 10 - 15VDC • Speed Out • Fault Out • Run/Stop, Freewheel and Direction • Selectable Ramp Up • TTL-CMOS Compatible Inputs • Compact Size (6.25” x 3.28” x 1.65”) • Dual Mounting...
    Page 3 September 2012 L0104053 Specifi cations Control Inputs: (TB1, Pins 1-3) TTL-CMOS Compatible Logic “0” = 0-0.8VDC Logic “1” = OPEN All three inputs (run/stop, freewheel, and direction) are pulled up through 20k Ohm resistors. Direction Control: (TB3, Pin 2) Logic “1” (open) - Clockwise Logic “0” - Counterclockwise Freewheel: (TB3, Pin 3) Logic “1” (open) - Motor is Enabled Logic “0” - Motor is de-energized and will coast Run/Stop: (TB3, Pin 4) Logic “1” (open) - Motor will not run and if running will come...
    Page 4 September 2012 L0104054 Hall Sensor Power Output: 6.25V @ 30mA maximum. Typical current draw from hall sensor is 20mA. All three Hall Sensor inputs are pulled up through 20K ohm resistors. Open Loop/Closed Loop (Constant Velocity Mode) The driver can either be set for Open Loop or Closed Loop operation. Open Loop operation is used for applications where the speed of the motor needs to change according to the load. Closed Loop operation is used for applications where speed regulation is needed. Under...
    Start reading Anaheim Brushless DC MDC151012301Brushless DC Driver Users Guide

    Related Manuals for Anaheim Brushless DC MDC151012301Brushless DC Driver Users Guide

    All Anaheim manuals