Anaheim Brushless DC MDC100050101 Brushless DC Driver Users Guide
View the Anaheim Brushless DC MDC100050101 Brushless DC Driver Users Guide for free. All the Anaheim manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.
![Page 2
General Description
The MDC100-050101 driver is designed to drive DC brushless motors at currents of up to 10A (peak)
and 50V. Using hall sensor feedback, a constant velocity mode can be selected. The driver is protected
against over current cycle-by-cycle), hall sensor error and under volta\
ge. When an error occurs, a fault
light is turned on to notify the user. Included on the drive is an internal potentiometer to control the
maximum phase current allowed into the motor and an internal...](http://img.usermanuals.tech/thumb/413/6228/w300_brushless-dc-mdc100050101-brushless-dc-driver-users-guide-1478893201_d-1.png "Page 2
General Description
The MDC100-050101 driver is designed to drive DC brushless motors at currents of up to 10A (peak)
and 50V. Using hall sensor feedback, a constant velocity mode can be selected. The driver is protected
against over current cycle-by-cycle), hall sensor error and under volta\
ge. When an error occurs, a fault
light is turned on to notify the user. Included on the drive is an internal potentiometer to control the
maximum phase current allowed into the motor and an internal...")
![Page 3
Specifications
Control Inputs: (TB2, Pins 3-5)
TTL-CMOS Compatible
Logic “0” = 0-0.8VDC
Logic “1” = OPEN
All three inputs (brake, enable and direction) are pulled up to throug\
h 40k ohm resistors.
Freewheel: (TB2, Pin 5)
Logic “1” (open) - Motor is Enabled
Logic “0” - Motor is de-energized and will coast
Direction Control: (TB2, Pin 4)
Logic “1” (open) - Clockwise
Logic “0” - Counterclockwise
Brake: (TB2, Pin 3)
Logic “1” (open) - Motor will not run and if running will decelerate rapidly
Logic “0” -...](http://img.usermanuals.tech/thumb/413/6228/w300_brushless-dc-mdc100050101-brushless-dc-driver-users-guide-1478893201_d-2.png "Page 3
Specifications
Control Inputs: (TB2, Pins 3-5)
TTL-CMOS Compatible
Logic “0” = 0-0.8VDC
Logic “1” = OPEN
All three inputs (brake, enable and direction) are pulled up to throug\
h 40k ohm resistors.
Freewheel: (TB2, Pin 5)
Logic “1” (open) - Motor is Enabled
Logic “0” - Motor is de-energized and will coast
Direction Control: (TB2, Pin 4)
Logic “1” (open) - Clockwise
Logic “0” - Counterclockwise
Brake: (TB2, Pin 3)
Logic “1” (open) - Motor will not run and if running will decelerate rapidly
Logic “0” -...")
