Amerimax Gutter Shingle User Manual

							Tools that may be required:
•   Tin snips or hacksaw to miter cut corners and cut pieces to length
•    Pliers to bend the lip of the gutter around gutter spikes
•    Power screw driver
  Starting at one end of the gutter, slightly lift the first row of shingles 
and slide the back edge of the gutter cover under the shingles (Fig. A), 
then pull the front edge of The Gutter Shingle forward so that it clips to 
the front edge of the gutter. (Fig. B) Note: If there is not enough space 
between the gutter lip and spike, you will need to bend the lip up a little 
or pinch the lip closed to allow the clip to fit over the lip. (Fig. C)
  If the roof shingles do not cover the back edge of gutter cover by at 
least one inch, it will be necessary to screw The Gutter Shingle to the 
front of the gutter using a sheet metal screw. (Fig. D)
  Install the next section using the same process as step 2. The notched 
clip will allow each section to overlap creating a seamless run of The 
Gutter Shingle.
  To fit outside corners, miter cut opposite ends of the two adjoining 
pieces to form a corner point (Fig. E). Note: To get an accurate cut, you 
should mark the cut with The Gutter Shingle in place on the gutter and 
roof. This will give the proper angle to miter cut each section.
  For inside corners, a small section of 1⁄4” mesh gutter guard ( Lock-On 
or Hinged ) may be required in the gutter where the roof valleys flow 
into the gutter and where upper roof downspouts flow into lower gutter.
(Fig. A)(Fig. B)
Helps Keep Leaves and Debris Out of Gutters.
Gutter Shingle
™
www.amerimax.com 800-347-2586 
™
© 2010 Amerimax Home Products, Inc.         201009
Call  today  to  find  out  more 
about  Amerimax’s  full  line 
of rain carrying products and 
accessories! 800-347-2586
•    Fine mesh screen helps block small debris
•    Textured paint blends with the shingles
•    Contractor quality with simple installation
•    Can be installed on any pitch roof
Installation Thoroughly clean gutter and downspout of any debris before beginning installation.
1
Step
2
Step
3
Step
4
Step
5
Step
(Fig. C)
(Fig. E)(Fig. D)