Amerimax Diamond Gutter Shield Installation User Manual
View the Amerimax Diamond Gutter Shield Installation User Manual for free. All the Amerimax manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.
![Page 1
Installation Instructions
Optional Tools Needed: Ladder, Safety Goggles, Gloves, Tin Snips & Metal\
Bending Tool
•
Ensure gutter syste m is clean and free of debris
• Inspect gutter ha ngers, e nsuri ng:
- tightly fastened to fascia and attached to gutter
- m inim um one hanger every 24 inches
•
Install fi rst Diam ond Gutter Shield
® at beginning of gutter run
• Measure 2 inches from end of Shield
• Cut and re move a notch fro m front and back edges
• Cut a line 2 long down...](http://img.usermanuals.tech/thumb/392/5738/w300_diamond-gutter-shield-installation-1478849762_d-0.png "Page 1
Installation Instructions
Optional Tools Needed: Ladder, Safety Goggles, Gloves, Tin Snips & Metal\
Bending Tool
•
Ensure gutter syste m is clean and free of debris
• Inspect gutter ha ngers, e nsuri ng:
- tightly fastened to fascia and attached to gutter
- m inim um one hanger every 24 inches
•
Install fi rst Diam ond Gutter Shield
® at beginning of gutter run
• Measure 2 inches from end of Shield
• Cut and re move a notch fro m front and back edges
• Cut a line 2 long down...")
![Page 2
•
W hen i nstalling each a dditional section, be sure to ove rlap the notche d areas
com pletely with previous section
• Overlapping each Shield section keeps debris out and adds support to th\
e
com pleted Shield system
•
Gutter sy stem corners require a butted mitre joint
• Measure from back corner of gutter syste m to ensure correct length
• Cut a 45 degree angle fro m the Drip Foot (back of Shield) to the Drip Lip
(front of Shield), careful not to dist ort the prof ile...](http://img.usermanuals.tech/thumb/392/5738/w300_diamond-gutter-shield-installation-1478849762_d-1.png "Page 2
•
W hen i nstalling each a dditional section, be sure to ove rlap the notche d areas
com pletely with previous section
• Overlapping each Shield section keeps debris out and adds support to th\
e
com pleted Shield system
•
Gutter sy stem corners require a butted mitre joint
• Measure from back corner of gutter syste m to ensure correct length
• Cut a 45 degree angle fro m the Drip Foot (back of Shield) to the Drip Lip
(front of Shield), careful not to dist ort the prof ile...")
