American Audio CDMp3 PLAYER Encore 2000 User Manual

BUTTON will instantly reactivate the SEAMLESS LOOP mode. To exit the loop, press the OUT BUTTON (12). 
LOOP will appear in the LCD DISPLAY (20) when the RELOOP function is available.
13. PLAY/PAUSE BUTTON - Each press of the PLAY/PAUSE BUTTON causes the operation to change from 
play to pause or from pause to play. While in play mode the blue play LED will glow, and while in pause mode 
the blue play LED will flash.
14. SOURCE SELECT BUTTON - This button lets you toggle between USB Port 1, USB Port 2, &...

 GENERAL FUNCTIONS AND CONTROLS (Cont.)                                       MIXER
B. MIXER CONTROLS (FIGURE 4)
21.  SOURCE SELECTOR SWITCH - These switches are used to select the input source assigned to 
each channel. Each channel may only be assigned one input source at a ti\
me. NOTE: When using 
deck output mode, switching to deck will route the deck source to the mix. 
22. AUX INPUT - This  Aux  input  is  for  the  use  of  a  Mp3  player. Input volume will be controlled by 
the channel two...

 for a maximum midrange gain of +12dB or maximum decrease of -30dB. Turning the knob in a   
 counter-clockwise direction will decrease the amount of midrange applied\
 to a channel signal, 
 turning the knob in a clockwise direction will increase the amount of mi\
drange applied to a    
 channel signal.
 BASS CONTROL - This knob is used to adjust the low frequency levels of a channel allowing    
 for a maximum bass gain of +12dB or maximum signal decrease of -30dB. Turning the k nob in   
 a...

 GENERAL FUNCTIONS AND CONTROLS (Cont.)             FRONT & REAR PANEL
©American Audio®   -   www.AmericanAudio.us   -   Encore 2000 Instruction Manual Page 14
Figure 6
Figure 5
C. FRONT PANEL (FIGURE 5)
34. TRANSPORT TRAY 1 - This tray is used to load and unload a compact disc. The tray is opened 
and closed by pressing the Deck 1 OPEN/CLOSE BUTTON (1). Never attempt to force the transport 
tray open or closed when the power is turned off. If the CD tray is left open for more than a minute it 
will...

 GENERAL FUNCTIONS AND CONTROLS (Cont.)            FRONT & REAR PANEL
©American Audio®   -   www.AmericanAudio.us   -   Encore 2000 Instruction Manual Page 15
TO THESE JACKS! CD players, Tape Decks and other line level instruments may be connected to 
these jacks. The red colored RCA jack represents the right channel input and the white represents 
the left channel input. Input volume will be controlled by channel one fader. The channel SOURCE 
SELECTOR SWITCH (21) must be in the "Line 1"...

©American Audio®   -   www.AmericanAudio.us   -   Encore 2000 Instruction Manual Page 16
 GENERAL FUNCTIONS AND CONTROLS (Cont.)                      CD PLAYER LCD
E. LCD DISPLAY PANEL (FIGURE 7)
47.  CUE INDICATOR - This indicator will glow when the unit is in CUE or PAUSE mode and will flash every time a new 
CUE POINT is set.
48. FOLDER INDICATOR - This indicator details the current selected folder.  
49.  TIME BAR INDICATOR - This bar gives a visual approximation of a track's or disc's...

©American Audio®   -   www.AmericanAudio.us   -   Encore 2000 Instruction Manual Page 17
INTERNAL MENU
Hold TIME BUTTON (3) for 3 seconds to enter the internal menu. Use the TRACK BUTTONS (18) or turn the JOG WHEEL 
(11) to scroll through the different menus and press the +10 BUTTON (18) to enter the corresponding submenu. Press 
the TRACK BUTTONS (18) or turn the JOG WHEEL (11) to change the submenus and press TIME BUTTON to memorize 
your settings in any operating mode and exit the menu.
1. PLAYLIST -...

©American Audio®   -   www.AmericanAudio.us   -   Encore 2000 Instruction Manual Page 18
 BASIC OPERATIONS
1.  LOADING/EJECTING DISCS & OR USB DEVICE
The  Encore  2000  can  only  play  3  inch  and  regular  5  inch  CDs.  When  loading  a  CD  into  the  player 
always hold the disc by it edge). Load the disc label side up and never touch the signal surface (the 
glossy side). To remove a disc from the player press the OPEN/CLOSE BUTTON (1).
CAUTION:
•   NEVER attempt to load any other objects besides...

©American Audio®   -   www.AmericanAudio.us   -   Encore 2000 Instruction Manual Page 19
Figure 11
Figure 12
Figure 9: Tapping the reverse 
track button will jump back 
to the previous track.
Figure 10: Tapping the for-
ward track button will skip 
forward to the next track.
2. SELECTING TRACKS
Select a desired track by using the TRACK BUTTONS (18). Tapping the TRACK BUTTONS (18) once will select 
either the next higher or lower track. You can hold down the TRACK BUTTONS (18) to change tracks continu-...

©American Audio®   -   www.AmericanAudio.us   -   Encore 2000 Instruction Manual Page 20
7. FRAME SEARCH 
This feature allows you to scroll through a track frame by frame, allowing you to 
find and set a starting cue or loop point. To use the scroll function you must first 
be in Pause Mode (see section 4) or Cue Mode (see section 8). Once y\
ou are in 
Pause or Cue mode, turn the JOG WHEEL (11) to scroll through the track (Figure 
13).  Turning  the  wheel  in  a  clockwise  direction  will  advance...