Home
>
AllTrade
>
Air Compressor
>
AllTrade Tradespro 5 Gal Air Compressor Reconditioned 835486 User Manual
AllTrade Tradespro 5 Gal Air Compressor Reconditioned 835486 User Manual
Here you can view all the pages of manual AllTrade Tradespro 5 Gal Air Compressor Reconditioned 835486 User Manual. The AllTrade manuals for Air Compressor are available online for free. You can easily download all the documents as PDF.
Page 11
ASSEMBLY INSTRUCTIONS THE COMPRESSOR IS SHIPPED WITHOUT OIL IN THE CRANKCASE. ADD OIL AS INDICATED BELOW. STEP 1 – PUMP LUBRICATION This air compressor features an oil lubricated pump that requires the use of SAE 30 weight non-detergent air compressor oil. Adding Compressor Oil: 1. Place air compressor on a flat, level surface. 2. Remove plastic oil fill breather plug (see Fig. 1). 4. See diagram for determining proper oil fill level using oil fill sight glass (see Fig. 3). 5. Install supplied plastic...
Page 12
OPERATION INITIAL SETUP / BREAK-IN PROCEDURE: Do not attach air hose, air tools or other air accessories to the air outlet until break-in procedure has been successfully completed. 1. Read and understand the entire instruction manual, including all safety warnings before setting up air compressor. 2. Place air compressor on a flat, level surface. 3. Check oil fill level in crankcase and add oil as needed. 4. Turn the pressure regulator knob fully clockwise to open airflow from air outlet port. Be...
Page 13
SHUTDOWN AND STORAGE: NOTE: NEVER stop the air compressor by unplugging it from the power outlet as this may result in damage to the compressor. 1.Turn the switch to the OFF position 2.Disconnect the power cord from the power outlet by grabbing the plug (not the cord). Loop around handle for storage. 3.Turn the pressure regulator knob fully counterclockwise to close airflow from air outlet port. Check the outlet pressure gauge to ensure that it reads 0 PSI. 4.Remove the air hose and any air accessories....
Page 14
CHECKING SAFETY RELIEF VALVE: SAFETY RELIEF VALVE MUST BE REPLACED IF IT CANNOT BE ACTUATED OR IT LEAKS AIR AFTER THE RING IS RELEASED. 1. The air compressor must be turned OFF. 2.Disconnect compressor from the power source. 3. Open tank drain to bleed off all air pressure before attempting any maintenance or repair. 4. Allow compressor to fully cool before attempting any maintenance or repair. 5. Grasp the wire ring on the safety relief valve. 6. Pull and release the ring a few times to ensure that the...
Page 15
13 TROUBLESHOOTING GUIDE Problem EncounteredPossible CausePossible Solution The compressor does not start or restart:Power cord not plugged in.Plug cord into grounded outlet. Motor/Pressure switch in OFF positionMove switch to AUTO position. Motor thermal overload switch hastripped.Turn air compressor off, wait until the motor is cool, thenpress motor thermal overload (red) button firmly until click is heard. Fuse blown or circuit breaker hastripped.Replace fuse or reset circuit breaker. Check for proper...
Page 16
14 TROUBLESHOOTING GUIDE Problem EncounteredPossible CausePossible Solution Air continues to leak atmotor/pressure switch releasevalve while motor is running: Defective motor/pressure switch.Replace. Check valve stuck in open position.Replace check valve. DANGER—Do not disassemble thecheck valve with tank pressurized. Open tank petcock valveto allow air to escape from tank prior to servicing. Air leaks from safety reliefvalve:Possible defective safety relief valve.Operate safety relief valve manually by...
Page 17
PARTS LIST 15 NO.PART NO.DESCRIPTIONQTYNO.PART NO.DESCRIPTIONQTY 1830241-1Air Filter155830241-55Air Tank Assembly1 2830241-2Elbow Connector156830241-56Pressure Regulator1 3830241-3Bolt M8x103457830241-57Quick Coupler1 4830241-4Cylinder Head158830241-58Handle Grip1 5830241-5Cylinder Head Gasket1 6830241-6Valve Plate1 7830241-7Valve Plate Gasket 1 8830241-8Pin _31 9830241-9Reed Valve1 10830241-10Cylinder1 11830241-11Cylinder Gasket1 12830241-12Piston Ring3 13830241-13Piston1 14830241-14Piston Pin Circlip...
Page 19
FACTORY RE-MANUFACTURED 30 DAY WARRANTY ALLTRADE TOOLS LLC AIR COMPRESSORS Express and Exclusive Limited Warranty to Original Retail Buyer Alltrade Tools LLC (hereinafter “Alltrade”) expressly warrants to the original retail purchaser of the accompanying air compressor and no one else all parts of the product (except those parts referred to below which are specifically excluded from such warranty (see Exclusions)) to be free from defects in materials for thirty (30) days from the original date of...
Page 20
WRITTEN OR ORAL, ARISES BY OPERATION OF LAW AND/OR EQUITY AND/OR BY ANY ACT OR OMISSION OF ALLTRADE AND/OR ITS REPRESENTATIVE(S), OR THE PURCHASER, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY EXPRESSLY EXCLUDED AND DISCLAIMED BY ALLTRADE AND/OR ITS REPRESENTATIVES. PURCHASER KNOWINGLY AND WILLINGLY WAIVES ANY AND ALL SUCH WARRANTIES AND RIGHTS, CLAIMS AND/OR CAUSES OF ACTION ARISING THEREFROM OR BASED THEREON....