Home > Alarm Lock > Alarm Lock > Alarm Lock Panic Exit Devic 265 265L 715 Installation Operation Instructions User Manual

Alarm Lock Panic Exit Devic 265 265L 715 Installation Operation Instructions User Manual

Add to Favourites
    Download as PDF

    View the Alarm Lock Panic Exit Devic 265 265L 715 Installation Operation Instructions User Manual for free. All the Alarm Lock manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 1 345 Bayview Avenue Amityville, New York 11701 CALL TOLL FREE: 800-ALA-LOCK (800) 252-5625 ELECTRONIC EXIT DOOR ALARMS PADDLE ARM MODEL 265/265L PUSH BAR MODEL 715 INSTALLATION AND OPERATION INSTRUCTIONS GENERAL DESCRIPTION Models 265, 265L (long arm) and 715 are non-handed, delayed egress, electronic exit door locking systems. Arming is accomplished by actuating the deadbolt using a 1 1/8” rim cylinder (not included). When armed, depressing the paddle (Model 265) or push bar (Model 715)...
    Page 2 2 requires an optional Surface Wiring Kit, Model SWK715, for routing of wires from the Lock Assembly to the Control Box. Note: If mounting onto a hollow door, wiring may be routed inside the door. A 3/8x36” straight drill will be required to drill through the door frame from the top and hinged-side edges and through internal reinforcements to allow snaking of wires. In this case, drill wire exit and entry holes and snake wires before mounting the Lock Assembly. Sufficient cable (10 feet) is...
    Page 3 3 washer from the Paddle Arm Hinge Bracket. Depress the Paddle Arm Hinge Bracket slightly and attach the Push Bar to the bracket using the #10-32 Phillips screw and lock washer just removed. Attach the End Cap to the Retaining Bracket using the #10-24x½” oval-head Phillips screw supplied. 8. Install the Keeper Assembly. Orient the Keeper Assembly against the door jamb so that the Cam Latch and the deadbolt on the lock are aligned with the respective holes in the Keeper Cover. Remove the...
    Page 4 4 together and Terminal 6 of all units must be connected together. Be sure to check that all doors unlock when the fire-panel relay opens. COMPLETING THE INSTALLATION 1. The Lock Assembly is factory wired to provide a continuous alarm when tripped until reset by disarming. For an automatic alarm shutdown after two minutes, remove the Shutdown Jumper (see Wiring Diagram). 2. Connect the battery clip to the 9-volt battery. 3. Replace the Lock Cover, being sure that the Cam Latch is first...
    Start reading Alarm Lock Panic Exit Devic 265 265L 715 Installation Operation Instructions User Manual

    Related Manuals for Alarm Lock Panic Exit Devic 265 265L 715 Installation Operation Instructions User Manual

    All Alarm Lock manuals