Home > Alarm Lock > Alarm Lock > Alarm Lock DL5200 Programming Manual

Alarm Lock DL5200 Programming Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Alarm Lock DL5200 Programming Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 84 Alarm Lock manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							11 
    When a key is pressed, a beep will sound and a Red LED will flash.  Other indications are:  
    ▪  Access Granted:  1 beep and a Green LED flash.  (When Pass Time ends, the DL5200 locks with a beep and a 
    Red LED flash). 
    ▪  Invalid Code Entered:  5 beeps and 5 Red LED flashes. 
    ▪  Disabled Code Entered:  5 beeps (with extended first beep) and 5 Red LED flashes. 
    ▪  New Access Code Accepted:  6 beeps and 6 Red LED flashes. 
    ▪  Programming Error:  2 sets of 5 beeps and 5 Red LED flashes. 
    ▪  Return from Anti Tamper Lockout:  2 beeps with a Red LED flash. 
    ▪  Low Battery:  High/Low sounder with flashing Red LED for 5 seconds.  (See below to replace batteries). 
     
    Note:  Keypress tones may be disabled using the ; 2 2 3 ; command (see Keypress Sound 
    Options, page 10). 
    Audible and LED Indications 
    Battery Replacement 
    Restore Factory Default (original settings that were set at the factory will be loaded). 
    1.   Remove the battery pack, and with the batteries disconnected, press any numeric key for 10 seconds and release. 
    2.   Connect the batteries and--within 3 seconds--press and hold ;.  After hearing 6 additional beeps, release ;.   
    The DL5200 is now clear of all programmed data, and the lock is now ready to accept new programming.  Important:  If 
    you do not hear these 6 beeps, you must start over at step 1.   
    Failure to follow this exact procedure can result in erratic lock behavior.   
    Erase All  Programming 
    When a valid code is entered and the batteries are weak, the YELLOW LED will light and the sounder will sound for 4 
    seconds.  DL5200 Series locks use five (5) AA-size 1.5 volt alkaline batteries.  Always replace weak batteries as 
    soon as possible. 
     
    The DL5200 is equipped with special non-volatile memory.  Thus if power is lost for ANY length of time (such as discon-
    necting the battery pack when replacing batteries or if the batteries die completely), all existing User Codes are retained 
    indefinitely. 
     
    CAUTION:  Do not press any keys while batteries are disconnected unless you intend to erase all programming
    .   
     
    See Installation Instructions for detailed illustrations and mounting instructions.   
     
    1. At the Secondary Lock Side, remove the handle by first inserting the key turning the key cylinder to a vertical po-
    sition.  Then insert the lever release pin (or a stiff wire such as a bent paper clip) into the underside handle re-
    lease hole and depress the lever catch.  Pull off lever.   
    2. Remove the two flat head screws from above and below the lever spindle and remove the two flat head screws 
    on the left and right side of the top of the lock housing. 
    3. Remove the secondary housing from the door by depressing the spring tab. 
    4. Pull out the battery pack and replace all 5 batteries. 
    5. If you do not hear the 3 beeps when power is re-applied, all programming and settings have been retained, and 
    the lock is ready for use.  Go to step 5. 
    6. If you do hear 3 beeps when power is re-applied, do not press any keys for 15 seconds.  After the 15 second 
    period, the LED will flash red 6 times and 6 beeps will sound.  Reset the clock using functions 38, 39 and 40.   
    7. To reinstall the Secondary Lock Side, reverse the procedure in step 4.  
    						
    							12 
    ALARM LOCK SYSTEMS, INC. (ALARM LOCK) 
    warrants its products to be free from manufacturing 
    defects in materials and workmanship for 24 months 
    following the date of manufacture. ALARM LOCK will, 
    within said period, at its option, repair or replace any 
    product failing to operate correctly without charge to 
    the original purchaser or user. 
    This warranty shall not apply to any equipment, or 
    any part thereof, which has been repaired by others, 
    improperly installed, improperly used, abused, altered, 
    damaged, subjected to acts of God, or on which any 
    serial numbers have been altered, defaced or 
    removed. Seller will not be responsible for any 
    dismantling or reinstallation charges. 
    THERE ARE NO WARRANTIES, EXPRESS OR 
    IMPLIED, WHICH EXTEND BEYOND THE 
    DESCRIPTION ON THE FACE HEREOF. THERE IS 
    NO EXPRESS OR IMPLIED WARRANTY OF 
    MERCHANTABILITY OR A WARRANTY OF 
    FITNESS FOR A PARTICULAR PURPOSE. 
    ADDITIONALLY, THIS WARRANTY IS IN LIEU OF 
    ALL OTHER OBLIGATIONS OR LIABILITIES ON 
    THE PART OF ALARM LOCK. 
    Any action for breach of warranty, including but not 
    limited to any implied warranty of merchantability, must 
    be brought within the six months following the end of 
    the warranty period. IN NO CASE SHALL ALARM 
    LOCK BE LIABLE TO ANYONE FOR ANY 
    CONSEQUENTIAL OR INCIDENTAL DAMAGES 
    FOR BREACH OF THIS OR ANY OTHER 
    WARRANTY, EXPRESS OR IMPLIED, EVEN IF THE 
    LOSS OR DAMAGE IS CAUSED BY THE SELLERS 
    OWN NEGLIGENCE OR FAULT. 
    In case of defect, contact the security professional 
    who installed and maintains your security system. In 
    order to exercise the warranty, the product must be 
    returned by the security professional, shipping costs 
    prepaid and insured to ALARM LOCK. After repair or 
    replacement, ALARM LOCK assumes the cost of 
    returning products under warranty. ALARM LOCK 
    shall have no obligation under this warranty, or 
    otherwise, if the product has been repaired by others, 
    improperly installed, improperly used, abused, altered, 
    damaged, subjected to accident, nuisance, flood, fire 
    or acts of God, or on which any serial numbers have 
    been altered, defaced or removed. ALARM LOCK will 
    not be responsible for any dismantling, reassembly or 
    reinstallation charges. 
    This warranty contains the entire warranty. It is the 
    sole warranty and any prior agreements or 
    representations, whether oral or written, are either 
    merged herein or are expressly cancelled. ALARM 
    LOCK neither assumes, nor authorizes any other person purporting to act on its behalf to modify, to 
    change, or to assume for it, any other warranty or 
    liability concerning its products. 
    In no event shall ALARM LOCK be liable for an 
    amount in excess of ALARM LOCKs original selling 
    price of the product, for any loss or damage, whether 
    direct, indirect, incidental, consequential, or otherwise 
    arising out of any failure of the product. Sellers 
    warranty, as hereinabove set forth, shall not be 
    enlarged, diminished or affected by and no obligation 
    or liability shall arise or grow out of Sellers rendering 
    of technical advice or service in connection with 
    Buyers order of the goods furnished hereunder. 
    ALARM LOCK RECOMMENDS THAT THE ENTIRE 
    SYSTEM BE COMPLETELY TESTED W EEKLY. 
    Warning: Despite frequent testing, and due to, but 
    not limited to, any or all of the following; criminal 
    tampering, electrical or communications disruption, it is 
    possible for the system to fail to perform as expected. 
    ALARM LOCK does not represent that the product/
    system may not be compromised or circumvented; or 
    that the product or system will prevent any personal 
    injury or property loss by burglary, robbery, fire or 
    otherwise; nor that the product or system will in all 
    cases provide adequate warning or protection. A 
    properly installed and maintained alarm may only 
    reduce risk of burglary, robbery, fire or otherwise but it 
    is not insurance or a guarantee that these events will 
    not occur. CONSEQUENTLY, SELLER SHALL HAVE 
    NO LIABILITY FOR ANY PERSONAL INJURY, 
    PROPERTY DAMAGE, OR OTHER LOSS BASED 
    ON A CLAIM THE PRODUCT FAILED TO GIVE 
    WARNING. Therefore, the installer should in turn 
    advise the consumer to take any and all precautions 
    for his or her safety including, but not limited to, fleeing 
    the premises and calling police or fire department, in 
    order to mitigate the possibilities of harm and/or 
    damage. 
    ALARM LOCK is not an insurer of either the property 
    or safety of the users family or employees, and limits 
    its liability for any loss or damage including incidental 
    or consequential damages to ALARM LOCKs original 
    selling price of the product regardless of the cause of 
    such loss or damage. 
    Some states do not allow limitations on how long an 
    implied warranty lasts or do not allow the exclusion or 
    limitation of incidental or consequential damages, or 
    differentiate in their treatment of limitations of liability 
    for ordinary or gross negligence, so the above 
    limitations or exclusions may not apply to you. This 
    Warranty gives you specific legal rights and you may 
    also have other rights which vary from state to state. 
    Alarm Lock Limited Warranty  
    						
    All Alarm Lock manuals Comments (0)

    Related Manuals for Alarm Lock DL5200 Programming Manual