Akai Dv R4410ss Operators Manual

English I/B Cover Page    I/B size: 148 x 210 mm    GB1~42
 

E - 1
Important Safety Instructions
WARNING: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING
The lightning flash with an arrowhead symbol, within the
equilateral triangle, is intended to alert the user to the
presence of uninsulated dangerous voltage within the
products enclosure that may be of sufficient magnitude
to cause an electric shock.
The exclamation point within the equilateral triangle...

E - 2
Important Safety Instructions
14. Outdoor Antenna Grounding - If an outside antenna or cable system is connected to the product, be sure the antenna
or cable system is grounded so as to provide some protection against voltage surges and built up static charges.
Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding
of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding
conductors,...

E - 3
Precaution for Discs
Handling Disc
• To keep the disc clean, do not touch the play sides of the side.
 Do not attach paper or ape to the disc.
 Keep the disc away from direct sunlight or heat sources.
 Store the disc in a disc case after playback.
Cleaning Disc
 Before playback, wipe the disc outwards from the center with clean cloth.
 Do not use any type of solvent such as thinner, benzine, commercially available cleaners or anti-static spray.
Precaution for Unit
Security
 Before operation,...

E - 4
Table of Contents
Repeat Playback ........................................ 26
Repeating a title/chapter (DVD) ............................ 26
Repeating a single track/whole disc (CD) ........... 26
Repeating a specific section (DVD) ...................... 26
Playing MP3 and Picture File Disc......... 27-28
Playing a MP3 file disc ............................................ 27
Playing a Picture file disc ....................................... 28
Playing a MP3/Picture file disc...

E - 5
The unit can playback discs bearing any of the following marks:
Region Management Information
Region Management Information: This unit is designed and manufactured to respond to the Region Management
Information that is encoded on DVD discs. If the Region number printed on the DVD disc does not correspond
to the Region number of this unit, this unit cannot play that disc.
The region number of this unit is 2.
Disc Function or Operation that is Not Available
When the  symbol appears on the TV screen,...

E - 6
BEFORE YOU  START
To install Batteries
1.Open the battery door.
Battery Replacement
When batteries become weak, the operating distance of the Remote Control is greatly reduced and you will
need to replace the batteries.
Notes:
• If the Remote Control is not going to be used for a long time, remove the batteries to avoid damage caused
by battery leakage corrosion.
 Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable
(NICKEL-CADMIUM) batteries.2.Insert two...

E - 7
PARTS AND FUNCTIONS
(Continued on next page) (Continued on next page)(Continued on next page) (Continued on next page)
(Continued on next page)
Remote Control
1) STANDBY  / ON button
Turns the Unit on and puts it in standby mode.
2) RETURN button
Return to the normal operation after using the SETUP
menu.
3) Number (0 - 9) and (+10) buttons
Use when creating programs, and entering a parental
level password. To select numbers over 9, press +10
button and then the second no. for example, to enter 18,...

E - 8
PARTS AND FUNCTIONS
Remote Control
(Continued on next page) (Continued on next page)(Continued on next page) (Continued on next page)
(Continued on next page)
19) FUNCTION button
Display the FUNCTION screen where you can check or
change various setting.
20) OPEN / CLOSE button
Use to open or close the disc tray.
21) GOTO button
Skip directly to a specific location on a DVD disc.
22) SOUND button
Selects sound balance and tone controls for adjustment
with the cursor buttons.
23) P. SCAN / CVBS...

E - 9
PARTS AND FUNCTIONS
Note:
Screen saver - If no button is pressed within 2 minutes,
the function will active, If you want to return the normal
screen, press any button. 1) Disc tray
Open or close tray by pushing OPEN/CLOSE button.
Place a disc on the disc tray, label side up.
2) STANDBY indicator
When the Unit is turned on by pressing the
STANDBY/ON button. If you press the STANDBY 
/
ON button on the remote control, the Unit will turn
off and go into standby mode. The light will continue
to...