Aiphone TW BeaconStrobe Instructions User Manual
Have a look at the manual Aiphone TW BeaconStrobe Instructions User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 161 Aiphone manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
IS Tower Strobe Strobe / Illumination Light Wiring Instructions The following instructions are for wiring the beacon/strobe light on top of TW-Series towers, as well as wiring the panel light located above the panel hole. These instructions apply to models: TW-LCB, TW-LCK, TW-LCR, TW-LCW, and TW-LCY. Locate the beacon/strobe wires and connect to a 24V DC power supply. • Red to +24V DC • Black to - (Ground) • Connect the white trigger wire to the Normally Open (NO) terminal of relay 2 on the IS emergency sub station. Connect a wire between the common terminal of relay 2 and the positive of the 24V DC power supply. Locate the panel light wires and connect to a 24V DC power supply. • Red to +24V DC • Black to - (Ground) OFF ON NO NOC NC C NC1234 Relay board on back of sub stations + - 24VDC Panel Light Strobe Refer to the sub station installation manual for its complete wiring and dip switch setting options. Pg. 1 Tower Strobe Instr. 0512PH
Pg. 2 Tower Strobe Instr. 0813PH Aiphone Corporation 1700 130th AVE NE Bellevue, WA 98005 Ph: (800) 692-0200 Fax: (425) 455-0071 [email protected] SPECIFICATIONS: Beacon / Strobe: Voltage: 24V DC Current: 300 mA 144 mA @ 24VDC in steady state mode 272 mA @ 24VDC in fl ashing mode Light source: LED Luminous output: 247 lm Wiring: Black: Ground Red: +24V DC White: Trigger (+24V DC) Wiring Distance: 18awg, 980’ Operating temp: -40°F to 149°F Panel light: Voltage: 24V DC Current: 24 mA Light source: LED Luminous output: 100 lm Wiring: Black: Ground Red: +24V DC Wiring Distance: 18awg, 980’ Operating temp: -40°F to 149°F 7” 7-¼”