Home > Aiphone > Telephone > Aiphone NIM Series Instructions User Manual

Aiphone NIM Series Instructions User Manual

Here you can view all the pages of manual Aiphone NIM Series Instructions User Manual. The Aiphone manuals for Telephone are available online for free. You can easily download all the documents as PDF.

Page 11

11
MOUNTING CONNECTION GETTING STARTEDAPPENDIX
SETUP AFTER 
INSTALLATION
Ceiling speaker, ceiling microphone
■ Ceiling speaker (NI-LB)                                                   ■ Ceiling microphone (NI-SB)
Main unitChinese RoHS 
paperMain unitWood screw 
(x2)
15 (9/16”)
ø180 (7-1/16”)
ø105 (4-1/8”)
5 (3/16”)
HolderChinese RoHS 
paper
65 
(2-9/16”)
 
Corridor light, reset button
■ Corridor light, single bed (NIR-4)
■ Corridor light, multiple beds (NIR-4S)                                        ■...

Page 12

12
■ Corridor light with reset button (NIR-42) 
Main unit Screw (x4)
120 (4-3/4”)
27 (1-1/16”) 116 (4-9/16”)
Chinese RoHS 
paper
■ Corridor light with buzzer (NIR-4BZ) 
Main unit Screw (x4)
120 (4-3/4”)
27 (1-1/16”) 116 (4-9/16”)
Chinese RoHS 
paper
■ Corridor light with nameplate, 1 name (NIR-31) 
Main unit Mounting bracketRoom number 
plateNameplate
144 (5-11/16”)
16 
(5/8”) 190 (7-1/2”)
24 (15/16”)
Screw (x4) Chinese RoHS paper
 (Front) 
 (Front) 
 (Side) 
 (Side) 
 (Front)  (Side)  

Page 13

13
MOUNTING CONNECTION GETTING STARTEDAPPENDIX
SETUP AFTER 
INSTALLATION
■ Corridor light with nameplates, 2 names (NIR-32) 
Main unit Mounting bracketRoom number 
plateNameplate (x2)
144 (5-11/16”)
16 
(5/8”) 190 (7-1/2”)
24 (15/16”)
Screw (x4) Chinese RoHS paper
 
■ Corridor light with nameplates, 4 names (NIR-34) 
Main unit Mounting bracketRoom number 
plateNameplate (x4)
144 (5-11/16”)
16 
(5/8”) 306 (12-1/16”)
24 (15/16”)Screw (x4) Chinese RoHS paper
 
 
Software
■ Call log software (NI-SOFT)
CD-ROM...

Page 14

14
MOUNTING
This section illustrates the mounting procedures for wall- and ceiling-mount equipment.
■ Ceiling speaker (NI-LB)
■ Ceiling microphone (NI-SB)
ø105mm (4-3/16”) 66.7mm (2-11/16”)
NOTE:
Make sure to mount the ceiling microphone 50 cm (20) apart from the ceiling speaker to prevent audio feedback.

Pay attention to the depth of the unit.
Use board anchors or concrete plugs as needed on a concrete wall.
Holder
Hook
Connector
Loop
Main unit
Main unit SpringCeiling
CeilingØ150mm 
(5-7/8)
Disconnect...

Page 15

15
MOUNTING CONNECTION GETTING STARTEDAPPENDIX
SETUP AFTER 
INSTALLATION
■ Wall jack (NIR-HP, NIR-1, NIR-MB, NIR-7BS)
  Call button (NIR-6)
  Corridor light (NIR-4, NIR-4S)
  Call reset button (NIR-2)
The illustration shows the wall jack for NI-RC (NIR-HP).* 
  Bathroom call button (NIR-7W, NIR-7HW)
The illustration shows the bathroom call button (NIR-7W).* 
CALL
Remove the front cover from 1 the main unit.
Install a single gang box 2 in the wall. Pass the wires 
through the gang box and 
make the wire...

Page 16

16
■ Sub station, surface mount (NI-BA)
When mounting NI-BA on a wall, follow the procedure shown below.* 
■ Sub station, fl ush mount (NI-JA)
Tighten Special screw x 4 
(included)46 mm
(1-13/16)
Loosen
Hexagonal wrench
(included)
Opening dimensions without a gang box
W: 90mm (3-9/16), H: 73mm (2-7/8), D: 54mm (2-1/8)Main unit 2-gang box
Install a 2 gang box in the wall. 1 Pass the wires through the 
gang box and make the wire 
connections with the terminal 
cover open.
Be sure to route the wires through...

Page 17

17
MOUNTING CONNECTION GETTING STARTEDAPPENDIX
SETUP AFTER 
INSTALLATION
■ Wall jack (NIR-HPF)
  Corridor light (NIR-42, NIR-4BZ)
■ Corridor light with nameplate (NIR-31, NIR-32, NIR-34)
The illustration shows the corridor light with nameplates, 4 names (NIR-34).* 
Mounting bracket 
(attached to the unit when shipped)
Main unit
Screw (for gang box) × 4 (included)Single, 2- or 3-gang box
Install a gang box in the wall.1 
NIR-31, NIR-32: 2-gang box(*)
NIR-34: 3-gang box(*)
(*): Recommended
Detach the...

Page 18

18
CONNECTION
Connection wiring diagram (outline) 
The following is an example of basic wiring diagram.
The wiring methods differ depending on the equipment used. Refer to page 20 to 29 for details about various wiring methods. * 
E
1
M
2
3
4
5
10
12
19
20
11
SK
S1
SK
S1
I-G
RXTX
Black
OrangeWhiteGrayOrange/
White
BlueYellowRed
Gray
White
PC
Blue
Blue
Blue
Blue
22
29
30
21
32
39
40
E
M
31
34
33
Gray White Blue
Blue
Red White
Black
Black
Yellow
RedBlue
or
NIR-8NI-LB
GreenBlack
Yellow
RedBlueGreenBlack...

Page 19

19
APPENDIX
MOUNTING CONNECTION GETTING STARTED
SETUP AFTER 
INSTALLATION
Red
Black
CALLBlue
Green
Blue
Blue
Blue
Blue
Red
Black
Blue
Red
Black
Blue
CALL
CALL
Blue Blue
Blue
Blue
II
Blue
Blue
Green
Green
BrownBlack
Black OrangeRed
Red Yellow
Blue Green
NIR-7W or 
NIR-7HW
NIR-7W or 
NIR-7HW
NIR-7W or 
NIR-7HW
Blue Blue
Blue
Blue
E
C
CE
CS M A
NIR-4
NIR-2NIR-4
NIR-2
NIR-8NIR-1
NIR-4
NIR-2
CALL
E
C
CE
CS M A
■ Wiring distance
Wire diameter Maximum distance
Master station - sub stationØ0.65mm (22 AWG)
Ø0.9mm...

Page 20

20
Handling cables
Notes about handling cables
Cables and connectors are not included with the products.* 
■ Notes on cables
Use PE (polyethylene)-insulated PVC jacketed cable.• 
Parallel or jacketed conductors, mid-capacitance, non-shielded cable 
is recommended.
Never use twisted pair cable or coaxial cable.
• 
■ How to connect or disconnect stranded wires.
To ensure that the wire wont bend, press the release button while inserting into terminal.• 
   
8mm(3/8")
■ Note about wire-to-wire...
Start reading Aiphone NIM Series Instructions User Manual

Related Manuals for Aiphone NIM Series Instructions User Manual

All Aiphone manuals