Aimco Brakes MSDSUnivis HVI 26 SPFOil User Manual
Here you can view all the pages of manual Aimco Brakes MSDSUnivis HVI 26 SPFOil User Manual. The Aimco Brakes manuals for Service/Miscellaneous are available online for free. You can easily download all the documents as PDF.
Page 1
7379058-00 UNIVIS HVI 26 MATERIAL SAFETY DATA BULLETIN ------------------------------------------------------------------------\ --- ------------------------------------------------------------------------\ -- 1. PRODUCT AND COMPANY IDENTIFICATION -------------------------------------------------------------------------- PRODUCT NAME: UNIVIS HVI 26 SUPPLIER: EXXON MOBIL CORPORATION 3225 GALLOWS RD. FAIRFAX, VA 22037 24...
Page 2
Even though initial symptoms from high pressure injection may be minimal or absent, early surgical treatment within the first few hours may significantly reduce the ultimate extent of injury. INHALATION: Not expected to be a problem. However, if respiratory irritation, dizziness, nausea, or unconsciousness occurs due to excessive vapor or mist exposure, seek immediate medical assistance. If breathing has stopped, assist ventilation with a mechanical device or...
Page 3
PERSONAL PRECAUTIONS: See Section 8 -------------------------------------------------------------------------- 7. HANDLING AND STORAGE -------------------------------------------------------------------------- HANDLING: High pressure injection under the skin may occur due to the rupture of pressurized lines. Always seek medical attention. No special precautions are necessary beyond normal good hygiene practices. See Section 8 for additional personal protection advice...
Page 4
BOILING POINT C(F): > 154(310) MELTING POINT C(F): NA FLASH POINT C(F): 94(201) (ASTM D-92) FLAMMABILITY (solids): NE AUTO FLAMMABILITY C(F): NA EXPLOSIVE PROPERTIES: NA OXIDIZING PROPERTIES: NA VAPOR PRESSURE-mmHg 20 C: < 0.1 VAPOR DENSITY: > 2.0 EVAPORATION RATE: NE RELATIVE DENSITY, 15/4 C: 0.86 SOLUBILITY IN WATER: Negligible PARTITION COEFFICIENT: > 3.5 VISCOSITY AT 40 C, cSt: 26.0 VISCOSITY AT 100 C, cSt: NE POUR POINT C(F): -59(-75) FREEZING POINT C(F): NE VOLATILE ORGANIC...
Page 5
The presence of additives in other tested formulations (in approximately the same amounts as in the present formulation) did not alter the observed effects. ---SUBCHRONIC TOXICOLOGY (SUMMARY)--- No significant adverse effects were found in studies using repeated dermal applications of similar formulations to the skin of laboratory animals for 13 weeks at doses significantly higher than those expected during normal industrial exposure. The...
Page 6
addition, the product is suitable for processing by an approved recycling facility or can be disposed of at an appropriate government waste disposal facility. Use of these methods is subject to user compliance with applicable laws and regulations and consideration of product characteristics at time of disposal. RCRA INFORMATION: The unused product, in our opinion, is not specifically listed by the EPA as a hazardous waste (40 CFR, Part 261D), nor is it...
Page 7
USE: HYDRAULIC OIL NOTE: PRODUCTS OF EXXON MOBIL CORPORATION AND ITS AFFILIATED COMPANIES ARE NOT FORMULATED TO CONTAIN PCBS. Health studies have shown that many hydrocarbons pose potential human health risks which may vary from person to person. Information provided on this MSDS reflects intended use. This product should not be used for other applications. In any case, the following advice should be considered: INDUSTRIAL LABEL Under normal conditions of intended use, this product does not...