Home > AEM > Digital Performance Gauges > AEM XWiFi Wideband UEGO EGT Controller 302067 User Manual

AEM XWiFi Wideband UEGO EGT Controller 302067 User Manual

Add to Favourites
    Download as PDF

    View the AEM XWiFi Wideband UEGO EGT Controller 302067 User Manual for free. All the AEM manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com Instruction Part Number: 10-2320 Rev 01  2009 AEM Performance Electronics Part Number 30-2320 AEM X-WIFI UEGO/EGT Module Figure 1. Wiring Schematic AEM X-WIFI Parts 1 x 30-2320 X-WIFI Module 1 x 30-2001 UEGO Sensor 1 x 35-8535 Install Kit (UEGO Bung and 6 Butt Connectors) 1 x 10-2320 Installation Instructions 1 x 35-3416 8-Pin Power...
    Page 2 Page 2 INSTALLATION 1. Disconnect the negative battery cable. 2. Find a suitable, in cab, mounting location and secure the X-WIFI module using the supplied zip ties. Note: The X-WIFI is not weatherproof and should not be mounted in the engine bay or exposed to outside elements 3. Plug the 8-pin power harness into the mating connector on the right side of the X- WIFI and connect the wires as shown in Figure 1. 4. Mount the UEGO sensor as shown in figure 3. 5. Connect the sensor to the X-WIFI...
    Page 3 Page 3 Displaying Data with WIFI Enabled Electronic Devices Real time AFR and EGT data from the X-WIFI can be viewed on WIFI enabled electronic devices using a standard web browser. Locate the network “AEM X-WIFI” and connect. Type the address 192.168.3.88 in the address bar of the browser and open the web page. A screen showing the AFR and EGT values will appear as shown below in Figure 2. If a UEGO sensor error is detected, the AFR value will display “Err” followed by a number. The number...
    Page 4 Page 4 Status Lights The AEM X-WIFI has two status lights, see Figure 4. The warm up status light on the left flashes during sensor warm up. Once the sensor reaches operating temperature, usually within 30 seconds, the light will remain on. During sensor warm up, AFR readings may not be accurate. The UEGO error status light on the right will flash if a sensor error is detected. The status light will flash on and off a number of times, followed by a short pause. The error codes are...
    Start reading AEM XWiFi Wideband UEGO EGT Controller 302067 User Manual

    Related Manuals for AEM XWiFi Wideband UEGO EGT Controller 302067 User Manual

    All AEM manuals