Home > AEM > Wideband UEGO Air/Fuel Controllers > AEM Flex Fuel Wideband Failsafe Gauge No FF Sensor 304910 User Manual

AEM Flex Fuel Wideband Failsafe Gauge No FF Sensor 304910 User Manual

Add to Favourites
    Download as PDF

    View the AEM Flex Fuel Wideband Failsafe Gauge No FF Sensor 304910 User Manual for free. All the AEM manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com Instruction Part Number: 10-4910 Rev B  2016 AEM Performance Electronics Instruction Manual P/N 30-4910 Wideband Ethanol Boost Gauge P/N 30-4911 Wideband Ethanol Boost Gauge This product is legal in California for racing vehicles only and should never be used on public highways. Wideband Ethanol Boost Gauge Parts List WARNING: ! This...
    Page 2 Page 3 GETTING STARTED THIS PRODUCT DOES NOT INCLUDE SOFTWARE IN THE PACKAGING. PLEASE DOWNLOAD AND INSTALL THE WIDEBAND ETHANOL BOOST CONFIGURATION SOFTWARE FROM THE AEM WEBSITE AT: www.aemelectronics.com/downloads Software Installation Instructions Follow the Installation Instructions as outlined in the forum post described above. After the software installation is complete, double-click on the AEM W ideband Ethanol Boost icon (shown below) to launch the application. Connect the USB...
    Page 3 Page 4 ECU / Datalogger Installation Diagram Installation 1. Disconnect the negative battery cable. 2. Temporarily install gauge without bracket into desired mounting location. Gauge mounts into a 2-1/16” (52MM) hole. The supplied rubber band can be used as a spacer around the gauge if it fits loosely in mounting hole. 3. Locate a suitable place in the exhaust system to install the included oxygen sensor weld bung. On non-turbocharged engines, mount the oxygen sensor in the exhaust...
    Page 4 Page 5 4. Next, the UEGO sensor 8-pin wiring harness should be routed to the oxygen sensor bung. Pin Color Description 1 N/C N/C 2 White Heat - 3 Orange VM 4 Green IA 5 Red IP 6 Black UN 7 N/C N/C 8 Brown 12V 5. Next the main 16-pin connector will be manually wired into the vehicle. Pin Color Description 1 Black Ground; connect to good chassis ground or directly to battery negative (−) terminal 2 Red Ignition power; connect to a fused key on +12V power source 3 Black USB -...
    Start reading AEM Flex Fuel Wideband Failsafe Gauge No FF Sensor 304910 User Manual

    Related Manuals for AEM Flex Fuel Wideband Failsafe Gauge No FF Sensor 304910 User Manual

    All AEM manuals