AEM CAS Trigger Disc 308761 User Manual
Here you can view all the pages of manual AEM CAS Trigger Disc 308761 User Manual. The AEM manuals for Sensors Connectors & Accessories are available online for free. You can easily download all the documents as PDF.
Page 21
Page 21 of 25 Figure 37: Hammering star socket to press on socket and bearing Similar to the removal of the pin, the reinstallation of the pin requires hammering the pin back into the hole on the star socket as shown in figure 38 Note: The socket must be aligned relative to the shaft before performing this step. Figure 38: Aligning the star socket retaining pin
Page 22
Page 22 of 25 Reinstall the screws that hold on the plastic CAS sensor with some threadlocker to the metal housing taking extreme care not to bend the trigger disc. This can be accomplished by lightly pulling the shaft as shown in figure 39. Figure 39: Reinstallation of CAS sensor screws Reinstall rubber seal for housing as shown in figure 40. Figure 40: CAS rubber seal reinstalled
Page 23
Page 23 of 25 Reinstall 2nd CAS housing half making sure that the plastic connector and rubber seal are aligned properly to avoid CAS sensor and disc damage. The housing should be able to be pressed on by hand with even pressure around the whole assembly. Once together, reinstall screws with threadlocker. See figure 41. Figure 41: Housing cover reinstalled Reinstall the plastic connector cover as shown in figure 42. Figure 42: Connector cover reinstalled
Page 24
Page 24 of 25 Align the CAS sensor with the mark you made at the beginning of the instructions or alternatively, look at the cam and align the sensor with the groove in the cam. Make sure that the sensor is seated properly before reinstalling the bolts. See figure 43. Figure 43: Reinstalling the CAS sensor Align bolts with previously made markings and tighten as shown in figure 44. Figure 44: Reinstalling CAS sensor bolts
Page 25
Page 25 of 25 Reattach the plastic connector to the CAS sensor after making sure the metal retaining clip is present and installed correctly. See figure 45. Figure 45: Replacing CAS sensor connector Reinstall the intake tube in the reverse of removal.