AEG Scs 51800 S0 User Manual

1.6 Service
• Any electrical work required to do the
servicing of the appliance should be
carried out by a qualified electrician or
competent person.
• This product must be serviced by an
authorized Service Centre, and only
genuine spare parts must be used.
1.7 Environment Protection
This appliance does not contain
gasses which could damage the
ozone layer, in either its refriger-ant circuit or insulation materials.
The appliance shall not be dis-
carded together with the urban
refuse and rubbish. The...

3.2 Freezing fresh food
The freezer compartment is suitable for
freezing fresh food and storing frozen
and deep-frozen food for a long time.
To freeze fresh foods it is not necessary
to change the medium setting.
However, for a faster freezing operation,
turn the temperature regulator toward
higher settings to obtain the maximum
coldness.
In this condition, the refrigerator
compartment temperature might
drop below 0°C. If this occurs re-
set the temperature regulator to
a warmer setting.
Place the fresh...

3.7 Movable shelves
The walls of the refrigerator are equip-
ped with a series of runners so that the
shelves can be positioned as desired.
3.8 Positioning the door
shelves
To permit storage of food packages of
various sizes, the door shelves can be
placed at different heights.
3.9 Positioning the sliding box
The sliding box can be placed at differ-
ent heights.
Do make these adjustments proceed as
follow:
1.lift the shelf with the sliding box up-
wards and out of the holders in the
door
2.remove the...

Meat (all types) : wrap in polythene bags
and place on the glass shelf above the
vegetable drawer.
For safety, store in this way only one or
two days at the most.
Cooked foods, cold dishes, etc..: these
should be covered and may be placed
on any shelf.
Fruit and vegetables: these should be
thoroughly cleaned and placed in the
special drawer(s) provided.
Butter and cheese: these should be
placed in special airtight containers or
wrapped in aluminium foil or polythene
bags to exclude as much air as...

• rinse and dry thoroughly.
Do not pull, move or damage
any pipes and/or cables inside
the cabinet.
Never use detergents, abrasive
powders, highly perfumed clean-
ing products or wax polishes to
clean the interior as this will dam-
age the surface and leave a
strong odour.
Clean the condenser (black grill) and the
compressor at the back of the appliance
with a brush. This operation will improvethe performance of the appliance and
save electricity consumption.Take care of not to damage the
cooling...

To remove the frost, follow the instruc-
tions below:
1.Switch off the appliance.
2.Remove any stored food, wrap it in
several layers of newspaper and put
it in a cool place.
CAUTION!
Do not touch frozen goods with
wet hands. Hands can freeze to
the goods.
3.Leave the door open and insert the
plastic scraper in the appropriate
seating at the bottom centre, plac-
ing a basin underneath to collect the
defrost water.
In order to speed up the defrost-
ing process, place a pot of warm
water in the freezer...

6. WHAT TO DO IF…
WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.There are some sounds during
normal use (compressor, refriger-
ant circulation).
ProblemPossible causeSolution
The appliance does
not operate. The
lamp does not oper-
ate.The appliance is switched
off.Switch on the appliance.
 The mains plug is not
connected to the mains
socket correctly.Connect the...

ProblemPossible causeSolution
 Products prevent that wa-
ter flows into the water
collector.Make sure that products
do not touch the rear
plate.
Water flows on the
ground.The melting water outlet
does not flow in the evap-
orative tray above the
compressor.Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low/high.The temperature regula-
tor is not set correctly.Set a higher/lower temper-
ature.
The temperature in
the refrigerator is
too high.There is no...

7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
7.2 Electrical connection
Before plugging in, ensure that the volt-
age and...

• Loosen and remove the lower pin.
On the opposite side:
• Tighten the lower pin.
• Install the lower door.
• Tighten the middle hinge.
• Install the spacer.
• Install the upper door.
• Tighten the upper pin.
7.4 Ventilation requirements
5 cmmin.
200 cm2
min.
200 cm2
The airflow behind the appliance must
be sufficient.
7.5 Installing the appliance
CAUTION!
Make sure that the mains cable
can move freely.Do the following steps:
x
x
If necessary cut the adhesive sealing
strip and apply it to the appliance...