AEG S 86378 Kg Operating Instructions

Installation
818 36 55-00/311
The refrigerator/freezer needs ventilation
Air is fed under the door through the 
vent slots in the base and is exhausted 
upwards along the back wall. To ensure 
proper air circulation never cover or 
alter the vent openings.
Important!  If the appliance is installed 
under a hanging cabinet, a clearance of 
at least 10 cm between the top of the 
appliance and the cabinet above it must 
be maintained.
Please check whether, after installing 
your appliance and especially...

Installation
12818 36 55-00/3
Electrical Connection
Any electrical work required to install this appliance should be carried 
out by a qualified electrician or competent person.
1 WARNING – THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety measures 
not be observed.
Before switching on, make sure the electricity supply voltage is the 
same as that indicated on the appliance rating plate. The rating plate is 
inside, on the left.
The appliance is supplied with a 13...

818 36 55-00/313
Carbon filter
There is a active carbon filter in the rear wall of the fridge section. The 
carbon filter cleans the air in the fridge section and in the LONGFRESH 
0°C cold section by binding unpleasant smells. 
Tip: The active carbon filter is a part subject to wear and is not covered 
by the warranty.
Inserting and changing the active carbon filter:
When the fridge is delivered, the carbon filter is packed in a plastic bag 
to ensure a long life. Before using the appliance for the...

14818 36 55-00/3
Appliance Description
View of Appliance
(various models)
áControl panel 
àButter and cheese compartment with lid
âDoor storage compartments
äBottle compartment
ãLONGFRESH 0 °C cold zone
åShelves
çQuick chill shelf
éBottle and can holder
èRating plate
êAir discharge grill with regulator
ëFreezer drawer (only for storage). When defrosting the bottom 
drawer also serves as a water collecting vessel
íFreezer drawer (for storage and freezing) 
ìFreezer tray
 

Appliance Description
818 36 55-00/315
Freezer tray 
In the freezer section there is a 
freezer tray in the second drawer 
from the top. It can be used in both 
the top drawer and the second 
drawer from the top.
Berries and vegetables, for example, 
can be pre-frozen on the freezer tray.
Advantage: The berries are not squeezed and maintain their natural 
form. The frozen berries can then be stored in compartments or drawers 
packaged in individual portions. 
Cold Accumulation Block
A cold accumulation...

Appliance Description
16818 36 55-00/3
Control panel
  1ON/OFF button
  2Fridge section indicator
  3Temperature indicator for fridge section (not for
LONGFRESH 0 °C cold section)
  4Buttons for setting temperature for fridge section
  5Thermometer indicator for fridge section (with COOLMATIC)
  6MODE button for setting the operating mode
  7Text display
  8RESET button
  9Freezer section indicator
  10Temperature indicator for freezer section
  11Buttons for setting temperature for freezer section...

Appliance Description
818 36 55-00/317
ACTUAL temperature means: 
The temperature display indicates the current temperature inside the 
fridge or the freezer compartment. The ACTUAL temperature is indi-
cated with static illuminated numbers.
3 Once the COOLMATIC- or the FROSTMATIC function has been switched 
on the DESIRED temperature that was set originally for the fridge or 
the freezer cannot be changed.
 
Temperature Displays
The temperature displays shows several 
types of information.
 In normal...

Appliance Description
18818 36 55-00/3
MODE button 
Different operating modes can be set using the MODE 
button. 
The following operating modes can be selected:
– SHOPPING: Fridge temperature value 3 °C for 6 hours, cooling for 
freezer section runs for 1 hour in continuous operation.
– FROSTMATIC: Cooling for the freezer section runs for 52 hours in 
 continuous operation.
– COOLMATIC: Fridge temperature value 3 °C for 6 hours.
– FROSTMATIC and COOLMATIC: 
Cooling for freezer section runs for 52 hours...

818 36 55-00/319
Prior to Initial Start-Up
1 Before connecting the appliance to the mains and putting it into ope-
ration for the first time, leave the appliance to stand for 30 minutes if 
was transported upright. After transport on its side, the appliance must 
be left to stand for 2 hours before putting it into operation. This is 
necessary to allow the oil to flow back into the compressor. Otherwise 
the compressor may be damaged.
0 1.Please clean the appliance interior and all accessories prior to...

20818 36 55-00/3
Initial Start-Up 
0 1.Insert plug into mains socket.
2.Press and hold down the ON/OFF button. The temperature indicator and 
the back lighting light up, the appliance starts up. An alarm sounds, 
TEMPERATURE appears in the display and the back lighting flashes in 
red.
3.Switch off alarm and red back lighting using RESET button. The 
TEMPERATURE indicator goes out, if the temperature in the appliance 
has gone below the warning temperature.
3 Temperature settings set in the factory: +5...