AEG Oven BE500352DM User Manual

							When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.10.7  Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.The top lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
11.  TROUBLESHOOTINGWARNING!
Refer to Safety chapters.11.1  What to do if...ProblemPossible causeRemedyYou cannot activate or oper-
ate the oven.The oven is not connected
to an electrical supply or it is
connected incorrectly.Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).The oven does not heat up.The oven is deactivated.Activate the oven.The oven does not heat up.The clock is not set.Set the clock.The oven does not heat up.The necessary settings are
not set.Make sure that the settings
are correct.The oven does not heat up.The automatic switch-off is
activated. Refer to "Automatic switch-
off". The oven does not heat up.The Child Lock is on.Refer to "Using the Child
Lock".ENGLISH31     
						

							ProblemPossible causeRemedyThe oven does not heat up.The fuse is blown.Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.The lamp does not operate.The lamp is defective.Replace the lamp.It takes too long to cook the
dishes or they cook too
quickly.The temperature is too low
or too high.Adjust the temperature if
necessary. Follow the advice
in the user manual.Steam and condensation
settle on the food and in the
cavity of the oven.You left the dish in the oven
for too long.Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.The display shows an error
code that is not in this table. There is an electrical fault.• Deactivate the oven with the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the error code again, contact
the Customer Care De-
partment.There is no good cooking
performance using the True
Fan Cooking PLUS function.You did not activate the
True Fan Cooking PLUS
function.Refer to "Activating the True
Fan Cooking PLUS func-
tion".There is no good cooking
performance using the True
Fan Cooking PLUS function.You did not activate correct-
ly the True Fan Cooking
PLUS function with the Plus
Steam button.Refer to "Activating the True
Fan Cooking PLUS func-
tion".There is no good cooking
performance using the True
Fan Cooking PLUS function.You did not fill the cavity
embossment with water.Refer to "Activating the True
Fan Cooking PLUS func-
tion".You want to activate the
True Fan Cooking function,
but the indicator of the Plus
Steam button is on.The True Fan Cooking PLUS
function operates.Push the Plus Steam button
 to stop the True Fan
Cooking PLUS function.
You want to activate the
cleaning function, but the
display shows "C4".The Plus Steam button is
pressed in.Press the Plus Steam button
again.The water in the cavity em-
bossment does not boil.The temperature is too low.Set the temperature at least
to 110 °C.
Refer to “Hints and tips”
chapter.www.aeg.com32  
						

							ProblemPossible causeRemedyThe water comes out of the
cavity embossment.There is too much water in
the cavity embossment.Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to the specific procedure.The appliance is activated
and does not heat up. The
fan does not operate. The
display shows  "Demo".The demo mode is activa-
ted.1. Deactivate the oven.
2. Press and hold the but-
ton 
.
3. The first digit on the dis- play and  Demo indicator
start to blink.
4. Enter the code 2468 by
pressing the buttons 
or  to change the val-
ues and press 
 to con-
firm.
5. The next digit starts to blink.
6. Demo  mode deactivates
when you confirm the
last digit and the code is
correct.
11.2  Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate ison the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.We recommend that you write the data here:Model (MOD.).........................................Product number (PNC).........................................Serial number (S.N.).........................................12.  ENERGY EFFICIENCY12.1  Product Fiche and information according to EU 65-66/2014Supplier's nameAEGENGLISH33     
						

							Model identificationBE500352DMEnergy Efficiency Index81.2Energy efficiency classA+Energy consumption with a standard load, conven-
tional mode1.09 kWh/cycleEnergy consumption with a standard load, fan-forced
mode0.69 kWh/cycleNumber of cavities1Heat sourceElectricityVolume71 lType of ovenBuilt-In OvenMass38.5 kgEN 60350-1 - Household electric cooking
appliances - Part 1: Ranges, ovens, steam
ovens and grills - Methods for measuring performance.12.2  Energy savingThe appliance contains
features which help you save
energy during everyday
cooking.General hints
Make sure that the oven door is closed
properly when the appliance operates
and keep it closed as much as possible
during the cooking.
Use metal dishes to improve energy
saving.
When possible, do not preheat the oven before you put the food inside.
When the cooking duration is longer
than 30 minutes, reduce the oven
temperature to minimum 3 - 10 minutes
before the end of the cooking time,
depending on the duration of the cooking. The residual heat inside the
oven will continue to cook.
Use the residual heat to warm up other
dishes.
Cooking with fan
When possible, use the cooking
functions with fan to save energy.
Residual heat
If a programme with the Duration or End
Time selection is activated and the cooking time is longer than 30 minutes,
the heating elements deactivate
automatically 10% faster in some oven
functions.
The fan and lamp continue to operate.Keep food warm
Choose the lowest possible temperature setting to use residual heat and keep ameal warm. The display shows theresidual heat indicator or temperature.
Cooking with the lamp off
Deactivate the lamp during cooking and
activate only when you need it.
Moist Fan Baking
Function designed to save energy during
cooking. It operates in such a way that
the temperature in the oven cavity may
differ from the temperature indicated on
the display during a cooking cycle and
cooking times may be different from the
cooking times in other programmes.
When you use Moist Fan Baking, the
lamp automatically deactivates after 30
seconds. You may activate the lamp
again but this action will reduce the
expected energy savings.
www.aeg.com34  
						

							13. ENVIRONMENTAL CONCERNSRecycle the materials with the symbol .
Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to recycle waste of electrical and electronic
appliances. Do not dispose appliancesmarked with the symbol  with the
household waste. Return the product to
your local recycling facility or contact
your municipal office.
*
ENGLISH35   
						

							www.aeg.com/shop867316807-C-432016