AEG Lavamat Ls 84840 User Manual

If you are unable to identify or solve the problem,
contact our service centre. Before telephoning,
make a note of the model, serial number and pur-
chase date of your machine: the Service Centre
will require this information.
TECHNICAL DATA
DimensionsWidth / Height / Depth60 / 85 / 63 mm
Electrical connectionVoltage
Overall power
Fuse
Frequency230 V
2200 W
10 A
50 Hz
Water supply pressureMinimum
Maximum0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Level of protection against ingress of solid particles and...

The consumption data shown on this chart is to be considered purely indicative, as it may
vary depending on the quantity and type of laundry, on the inlet water temperature and on
the ambient temperature.
INSTALLATION
Unpacking
All transit bolts and packing must be removed before using the appliance.
You are advised to keep all transit devices so that they can be refitted if the machine ever
has to be transported again.
1. After removing all the packaging, care-
fully lay machine on it’s back to remove...

3. Unscrew the three bolts with the key
supplied with the appliance.
4. Slide out the relevant plastic spacers.
5. Fill the smaller upper hole and the two
large ones with the corresponding plas-
tic plug caps supplied in the bag con-
taining the instruction booklet.
Installation33
 

Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine
is not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the floor
by putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the machine
next to a gas cooker or coalburning stove, an in-
sulating panel covered with aluminium foil on the
side facing the...

3. Set the hose correctly by loosening the
ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Installation should comply with local water
authority and building regulations...

This could be done by tying it to the tap
with a piece of string or attaching it to
the wall.
2.In a sink drain pipe branch. This branch
must be above the trap so that the bend
is at least 60 cm above the ground.
3.Directly into a drain pipe at a height
of not less than 60 cm and not more
than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside
diameter of the drain hose.
The drain hose must not be kinked.
The drain hose...

WARNING!
Should the appliance power supply cable need to be replaced, this must be carried out
by a Service Centre.
ENVIRONMENT CONCERNS
The symbol  on the product or on its packaging indicates that this product may not be
treated as household waste. Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the
environment and human...

38
 

39
 

www.aeg.com/shop132957921-A-202011