AEG Lavamat 74850 M User Manual

41Installation
4.Unscrew and remove the two large rear bolts B
and the six smaller bolts C.
5.Remove the bracket Dand tighten up the six
smaller bolts C. Slide out the relevant plastic
spacerE.
6.Open the porthole, take out the inlet hose from the
drum and remove the polystyrene block fitted on the
door seal.
7.Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the bag
containing the instruction booklet.
8.Connect the water inlet hose as described...

42Installation
Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the floor by
putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the machine next to a gas cooker or coal-
burning stove, an insulating panel covered with aluminium foil on the...

43Installation
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you
will have to purchase a new, longer hose specially
designed for this type of use.
Installation should comply with local water authority
and building regulations requirements. A minimum
water pressure of 0.05 MPa is required for safe
operation of the appliance.
If you cannot make the cold water connection direct from
the rising mains, you may be able to operate the appliance
from your cold...

44Installation
When discharging into a standpipe
ensure that the top of the standpipe is
no more than 90 cm (35.4) and no less
than 60 cm (23.6) above floor level.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Force Centre.
The joining piece must have an internal
diameter of 18 mm.
If your drain hose looks like this (see the relevant
pcture) you do not require the “U” piece”. Just push
the hose firmly into the...

45Environment concerns
In the interest of the environment
Washing machines and dishwashers
should be connected to the FOUL
drainage system, the water will then
be taken to a sewage works for
treatment before being discharged
safely into a river.
It is essential that these appliances
are not connected to the surface
water drainage system as this water
is discharged directly into a river or
stream and may cause pollution.
If you require any further advice
please contact your local water
authority....

46Installation
If you fit your own plug, the colours of the wires in the mains lead of your appli-
ance may not correspond with the markings identifying the terminals in your plug,
proceed as follows:
Connect the green and yellow (earth) wire to the terminal in the plug which is
marked with the letter «E» or the earth symbol  or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the plug which is marked with
the letter «N» or coloured black.
Connect the brown (live) wire to the...

47Environment concerns 
Enviroment concerns
Packaging materials
The materials marked with the symbol  are recyclable.
>PEPSPP

48Guarantee/Customer Service
Standard guarantee conditions 
We, AEG-Electrolux , undertake that if within 12 months of the date of the pur-
chase this AEG-Electrolux appliance or any part thereof is proved to be defective
by reason only of faulty workmanship or materials, we will, at our option repair or
replace the same FREE OF CHARGE for labour, materials or carriage on condition
that: 
 The appliance has been correctly installed and used only on the electricity
supply stated on the rating plate. 
 The...

49Guarantee/Customer Service
For the address of your local Service Force Centre and further information about
Service Force, please visit the website at:
www.serviceforce.co.uk
Before calling out an engineer, please ensure you have read the details under the
heading Something not working 
When you contact the Service Force Centre you will need to give the following
details: 
1Your name, address and postcode. 
2Your telephone number. 
3Clear concise details of the fault. 
4The model and Serial number of...

50Notes
132966711.qxd  05/03/2008  14.50  Pagina  50