AEG Lavamat 74850 M User Manual

Display (9)
Temperature indicator and COLD  symbol
Spin Speed indicator, RINSE HOLD , NIGHT CYCLE - symbols
Programme progress display: PREWASH , MAIN WASH , RINSE , SPIN ,
DRAIN , OVERDOSAGE
The programme progress display shows the washing phases of the selected
programme.
During a washing cycle, a black line blinks under the washing phase symbol of
the running programme. At the end of each washing phase, the line under the
corresponding symbol becomes fixed.
If the OVERDOSAGE symbol lights up at the...

The display shows the following information:
Duration of the selected programme
After selecting a programme, the duration is displayed in hours and minutes (for
example 
2.05). The duration is calculated automatically on the basis of the
maximum recommended load for each type of fabric.
After the programme has started, the time remaining is updated every minute.
Delay start
The selected delay (20 hours max) set by means of the relevant button appears
on the display for about 3 seconds (for example 
90’),...

13Use 
First Use
Ensure that the electrical and water connections comply with the installation
instructions.
Remove the polystyrene block and any material from the drum.
Run a cotton cycle at 95°C, without any laundry in the machine, to remove any
manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent
into the dispenser drawer and start the machine.
Personalization
Acoustic signals
The machine is provided with the acoustic device, which sounds in the following
cases:
●at the end of...

14Use
Daily Use
Load the laundry
1.Open the door by carefully pulling the door
handle outwards. Place the laundry in the drum,
one item at a time, shaking them out as much
as possible.
2.Close firmly the door. You must hear a click
during closing.
Attention!Do not embed the laundry
between the door and the rubber joint.
Measure out the detergent and the fabric softener
Your new appliance was designed to reduce
water, energy and detergent consumption.
1.Pull out the dispenser drawer until it
stops....

15Use
Select the required programme by means of programme selector
dial (1)
You can choose the right programme for any type of laundry following the
descriptions on the washing programme tables (see «Washing Programmes»).
Turn the programme selector dial to the required programme. The programme
selector determines the type of washing cycle (e.g. water level, drum movement,
number of rinses) and the washing temperature according to the type of laundry.
The pilot light of button 
7starts blinking and the...

16Use
RINSE HOLD: by selecting this option the water of the last rinse is not emptied out
to prevent the fabrics from creasing. At the end of the programme, 
0and RINSE
HOLD symbol appear on the display, DOOR symbol (door locked) remains lit, the pilot
light of button 
7goes off and the door is blocked to indicate that the water must
be emptied out.
NIGHT CYCLE: by selecting this option, the machine will not drain the water of the
last rinse, so as not to wrinkle the laundry. As all spinning phases are...

17Use
The Prewash ends with a short spin in programmes for COTTON and SYNTHETIC
fabrics, whereas in the programmes for DELICATE fabrics the water is only
drained. The relevant symbol will appear on the display.
STAIN option
Select this option to treat heavily soiled or stained laundry with stain remover
(extended main wash with time optimised stain action phase).
This option is notavailable with a temperature lower than 40°C.
Attention!If you wish to perform a programme with the stain option, pour stain...

18Use
The display will show the shorted washing time. To be used for very lightly soiled
laundry only.
Press the START/PAUSE (button 7)
To start the selected programme, press the button 7; the corresponding red pilot
light stops blinking.
The DOOR symbol appears on the display to indicate that the appliance has started
operating and the door is locked.
To interrupt a programme which is running, press the button 
7:the corresponding
red pilot light starts blinking.
To restart the programme from the point...

19Use
Cancelling the delayed start:
●set the washing machine to PAUSE by pressing the button 7;
●press the button 8 until the symbol 0’is displayed;
●press the button 7again to start the programme.
The button 
8cannotbe selected with DRAIN programme.
Altering an option or a running programme
It is possible to change any option before the programme carries it out. Before
you make any change, you must pause the washing machine by pressing the
button 
7.
Changing a running programme is possible only by...

20Use
At the end of the programme
The machine stops automatically, the pilot light of button 7 7pilot light goes off,
a blinking 
0appears on the display and the acoustic signal sounds for some
minutes.
If you have choosen a programme or an option that ends with water in the tub,
follow the below instruction to empty the water out: :
●turn the programme selector dial to O/OFF
●select the DRAINING or SPINNING programme
●reduce the spin speed if needed, by means of the relevant button
●press the button 7...