AEG Lavamat 72850 User Manual

41Something not working 
Problem Cause possible/Solution
No water is visible in the drum:
Machines based on modern technology operate very
economically using very little water without affecting
performance.
If you are unable to identify or solve the problem,
contact our service centre. Before telephoning,
make a note of the model, serial number and
purchase date of your machine: the Service Centre
will require this information.

	

	
...

42Technical data
Technical Data
Dimensions
Width
Height
Depth
(door included)60 cm
85 cm
63 cm
Electrical connection
Water supply pressureMinimum
Maximum0,05 MPa
0,80MPa
Maximum LoadCottons7,0 kg
Spin SpeedMaximum1200 rpm
Power supply voltage/frequency
Total power absorbed
Minimum fuse protection230 V/50 Hz
2200 W
10 A
132969360_EN.qxd  22/08/2007  17:28  Pagina  42
 

43Consumption value
The consumption data shown on this chart is to be considered purely indicative, as
it may vary depending on the quantity and type of laundry, on the inlet water
temperature and on the ambient temperature. It refers to the highest temperature
for each wash programme.
(*) 
«Economy 60°C»with a load of 7 kg is the reference programme for the data
entered in the energy label, in compliance with EEC 92/75 standards.
Drain--
Spin--
Delicate Spin--
Wool 40°620,4
Lingerie 40°600,35
Silk...

44
Installation
Unpacking
All transit bolts and packing must be removed before using the appliance.
You are advised to keep all transit devices so that they can be refitted if the
machine ever has to be transported again.
1.After removing all the packaging, carefully lay
machine on it’s back to remove the
polystyrene base from the bottom.
2.Remove the power supply cable and the
draining hose from the hose holders on the rear of the
appliance.
3.
With a suitable spanner unscrew and remove the
central rear...

4.Unscrew and remove the two large rear bolts B
and the six smaller bolts C.
5.Remove the bracket Dand tighten up the six
smaller bolts C. Slide out the relevant plastic
spacerE.
6.Open the porthole, take out the inlet hose from the
drum and remove the polystyrene block fitted on the
door seal.
7.Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the bag
containing the instruction booklet.
8.Connect the water inlet hose as described under the
paragraph...

Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the floor by
putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the machine next to a gas cooker or coal-
burning stove, an insulating panel covered with aluminium foil on the side facing
the...

Do not place the inlet hose downwards. Angle the hose to the left or
right depending on the position of your water tap.
3. Set the hose correctly by loosening the ring nut. 
After positioning the inlet hose, be sure to tighten the ring nut again to prevent
leaks.
4. Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with
the appliance. 
The inlet hose must not be lengthened. If it is too short and you do not wish to
move the tap, you will have to purchase a new, longer hose...

48
Important!
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and
joining piece is available from your local Service Centre.
Electrical connection
Information on the electrical connection is given on the rating plate on the inner
edge of the appliance door and in the chapter «Technical Data».
Check that your domestic electrical installation can take the maximum load
required, also taking into account any other appliances in use.
Connect the machine to an earthed socket....

Enviroment concerns
Packaging materials
The materials marked with the symbol  are recyclable.
>PEPSPP

50European guarantee
European Guarantee
This appliance is guaranteed by Electrolux in each of the countries listed at the
back of this user manual, for the period specified in the appliance guarantee
orotherwise by law. If you move from one of these countries to another of the
countries listed, the appliance guarantee will move with you subject to the
following qualifications:
The appliance guarantee starts from the date you first purchased the appliance
which will be evidenced by production of a valid...