AEG Lavamat 72850 User Manual

Control panel
Henceforth the programme selector dial, the buttons and the display will be
indicated with the numbers given in this table.
TIME SAVING button
START/PAUSE button
DELAY START button
DisplayProgramme selector dial
TEMPERATURE button
SPIN REDUCTION button
OPTIONS button
OK button


	


	
 



 


















	

 	
 



!


 
 ...

Display (9)
Temperature - symbol
Spin Speed, Rinse Hold  , Night Cycle  - symbols
Programme progress display: PREWASH , MAIN WASH , RINSE , SPIN ,
DRAIN , OVERDOSAGE
The programme progress display shows the washing phases of the selected
programme.
During a washing cycle, a black line flashes under the washing phase symbole of
the running programme. At the end of each washing phase, the line under the
corresponding symbol becomes fixed.
If the symbol OVERDOSAGE lights up at the end of the programme, it...

The display shows the following information:
Duration of the selected programme
After selecting a programme, the duration is displayed in hours and minutes (for
example 
2.05). The duration is calculated automatically on the basis of the
maximum recommended load for each type of fabric.
After the programme has started, the time remaining is updated every minute.
Delay start
The selected delay (20 hours max) set by means of the relevant button appears
on the display for about 3 seconds (for example 
90’),...

14First use
First Use
Ensure that the electrical and water connections comply with the installation
instructions.
Remove the polystyrene block and any material from the drum.
Run a cotton cycle at 95°C, without any laundry in the machine, to remove any
manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent
into the dispenser drawer and start the machine.
Personalization
Acoustic signals
The machine is provided with the acoustic device, which sounds in the following
cases:
●at the...

15Daily use
Daily Use
Load the laundry
1.Open the door by carefully pulling the door
handle outwards. Place the laundry in the drum,
one item at a time, shaking them out as much
as possible.
2.Close firmly the door. You must hear a click
during closing.
Attention!Do not embed the laundry
between the door and the rubber joint.
Measure out the detergent and the fabric softener
Your new appliance was designed to reduce
water, energy and detergent consumption.
1.Pull out the dispenser drawer until it
stops....

16Use
Select the required programme by means of programme selector
dial (1)
You can choose the right programme for any type of laundry following the
descriptions on the washing programme tables (see «Washing Programmes»).
Turn the programme selector dial to the required programme. The programme
selector determines the type of washing cycle (e.g. water level, drum movement,
number of rinses) and the washing temperature according to the type of laundry.
The pilot light of button 
7starts to flash and the...

must be emptied out.
Night cycle:by selecting this option, the machine will not drain the water of the
last rinse, so as not to wrinkle the laundry. As all spinning phases are suppressed,
this washing cycle is very noiseless and it can be selected at night or in times with a
more economical power rate
.In some programmes the rinses will be performed
with more water. At the end of the programme, 
0 and RINSE HOLD symbol will
flash on the display, the DOOR symbol remains lit, the pilot light of button...

18use
STAIN option
Select this option to treat heavily soiled or stained laundry with stain remover
(extended main wash with time optimised stain action phase).
This option is notavailable with a temperature lower than 40°C.
Attention!If you wish to perform a programme with the stain option, pour stain
remover into compartment  .
SENSITIVE option
By selecting this button the washing intensity will be reduced. The machine adds
one rinse in the programmes for COTTONS, 40°-60° MIX and SYNTHETICS. 
This...

19use
Press the START/PAUSE (button 7)
To start the selected programme, press the button 7; the corresponding red pilot
light stops flashing.
The DOOR symbol appears on the display to indicate that the appliance has started
operating and the door is locked.
To interrupt a programme which is running, depress the button 
7:the
corresponding red pilot light starts to flash.
To restart the programme from the point at which it was interrupted, pressthe
START/PAUSEbuttonagain.
If you have chosen a delayed...

20use
Cancelling the delayed start:
●set the washing machine to PAUSE by pressing the button 7;
●press the button 8 until the symbol 0’is displayed;
●press the button 7again to start the programme.
The DELAY START option can not be selected with DRAIN programme
.
Altering an option or a running programme
It is possible to change any option before the programme carries it out. Before
you make any change, you must pause the washing machine by pressing the
button 
7.
Changing a running programme is possible...