AEG Lavamat 48580 Information Manual

User information
31
Drain residual water:
Put a receptacle under the drain.  Turn the
cap in the anti-clockwise direction until it is
vertical to release residual water.
Remove the filter:
Unscrew the cap all the way and take it off.
Clean it tho-roughly with running water.
Put the assembly back and screw it in the
clockwise direction.
After cleaning the filter, you are required to closed the door. In fact,
for reasons of safety, the door must be closed when the appliance is
working.
 

User information
32
Operating problems
Many checks have been carried out during the manufacture of your
washing machine. However, if you face a problem with its operation,
please have a look at the following table before calling the After Sales
Service. Moreover, it is possible that one of the following messages
appears on the display :
Problem with water supply : No incoming water. Check tape &
 hose»
Problem with water draining : .....No drain. Check drain hose / filter»
Cover open :...

User information
33
The washing machine will
not spin or will not empty :•the drain pipe is blocked or kinked (No
drain. Check drain hose / filter)
•the drain filter is blocked (No drain.
Check drain hose / filter)
•the anti-unbalance mass safety device
has tripped; bad distribution of
washing in the drum,
•the «Drain» program or the «Rinse hold»
option is selected,
•the height of the drain siphon is
wrong.
There is water on the floor
around the washing
machine :•excess detergent has made too much
foam...

User information
34
The machine is vibrating or
noisy :•not all the packing was removed from
the machine (see unpacking section),
•the washing machine is not leveled
and properly packed,
•the washing machine is too close to
the wall or furniture,
•the washing is not well distributed in
the drum,
•the load is not sufficient.
The washing cycle is much
too long :•the water inlet is blocked (No inco-
ming water. Check tape & hose)
•there was a power supply failure or the
water was cut off,
•the motor...

User information
35
The following message
«Door not closed. Please
check» appears in the
display window :•the cover is not correctly closed.
The following message «No
drain. Check drain hose /
filter» appears in the
display window :•the drain filter is blocked,
•the drain pipe is blocked or kinked,
•the drain pipe is too high (see «instal-
lation»)
•the drain pump is blocked,
•the installation siphon is blocked.
The following message «No
incoming water. Check
tape &
 hose» appears in
the display window...

User information
36
The following message
«Warning : E / See
instructions booklet»
appears in the display
window or the washing
machine will not start or
will be in Pause :•turn the programme selector on the
OFF position and call the After Sales
Service.
* Depending on the model.
SymptomCause
 

User information
37
B - FOR THE INSTALLER
Installation and connection instructions
Warnings
•This washing machine is heav y. Take care when moving it.
• You must remove the packing on the washing machine before
use. Failure to remove all transport protection devices can cause
damage to the washing machine or nearby furniture. The washing
machine must be unplugged while packing is being removed.
• Do not allow any one other than a qualified plumber to make the
hydraulic connections necessary to install...

User information
38
Installation
 Unpacking
Packing used to protect internal parts of the washing 
machine during transport must be removed before the 
washing machine is put into service for the first time.
Remove all packing from the washing machine.
Tilt the washing machine sideways and then
remove the packing under the motor, and
straighten the washing machine.
Tilt the washing machine backwards, rotate it
by a quarter of a turn on one of its corner to
remove the transport base.
Open the washing...

User information
39
You can now see the openings that must be
closed with the caches in the pack attached to
the washing machine; do not forget to fold
down the central capsule.
Make sure that you have removed all these
parts from your washing machine and keep
them so that you can use them again if you
need them for future transport.
If the appliance is packed again, the springs
(components of the two spacers) must be
imperatively compressed between 21 and 24
mm after tightening.
*
(model LAVAMAT 48580)...

User information
40
Moving your washing machine
If you want to move your washing machine, lift
it onto its rollers by pulling the lever at the
bottom of the washing machine all the way to
the left. When you have put your washing
machine into the required location, put the lever
back into its initial position
Leveling
Precise leveling will prevent vibrations, noise and movements of the
washing machine during operation.
Make the washing machine level by adjusting
the leveling screw that is too short....