AEG L 71060 Sl User Manual

6.Put one of the polystyrene packag-
ing elements on the floor behind
the appliance. Carefully put down
the appliance with the rear side on
it. Make sure not to damage the
hoses.
1
2
7.Remove the polystyrene protection
from the bottom.
8.Pull up the appliance in vertical po-
sition.
9.Remove the power supply cable
and the drain hose from the hose
holders.
10.Remove the three bolts. Use the
key supplied with the appliance.
11.Pull out the plastic spacers.
ENGLISH31
 

12.Put the plastic caps in the holes.
You can find these caps in the user
manual bag.
– We recommend that you
keep the packaging and the
transit bolts for when you
move the appliance.
– If the appliance is delivered in
the winter months when there
are minus temperatures. Store
it at room temperature for 24
hours before using for the first
time.
POSITIONING AND LEVELLING
x4
• Install the appliance on a flat hard
floor.
• Make sure that carpets do not stop
the air circulation below the appli-
ance.
• Make...

• The appliance must be level and sta-
ble.
CAUTION!
Do not put cardboard, wood or
equivalent materials below the
appliance feet to adjust the lev-
el.
THE INLET HOSE
20O20O20O45O45O45O
• Connect the hose to the appliance.
Turn the inlet hose only left or right.
Loose the ring nut to set it in the cor-
rect position.
• Connect the water inlet hose to the
cold water tap with 3/4 thread.
CAUTION!
Make sure that there are no
leaks from the couplings.
Do not use an extension hose if
the inlet hose is too...

Water-stop device
A
The inlet hose has a water stop device.
This device prevents water leaks in the
hose because of its natural ageing. The
red sector in the window «A» shows this
fault .
If this occur, close the water tap and
contact the service centre to replace
the hose.
WATER DRAINAGE
There are different procedures to con-
nect the drain hose:
With the plastic hose guide.
 
• On the edge of a sink.
• Make sure that the plastic guide can-
not move when the appliance drains.
Attach the guide to the...

Without the plastic hose guide.
•To a sink spigot.
Refer to the illustration. Put the drain
hose in the spigot and tighten it with
a clip. Make sure that the drain hose
makes a loop to prevent that remain-
ing particles go in the appliance from
the sink.
• Directly to a built-in drain pipe in the
room wall and tighten it with a clip.
You can extend the drain hose
to maximum 400 cm. Contact
the service centre for the other
drain hose and the extension.
ENGLISH35
 

www.aeg.com/shop132930200-A-372011