AEG L 71060 Sl User Manual

							6.Put one of the polystyrene packag-
ing elements on the floor behind
the appliance. Carefully put down
the appliance with the rear side on
it. Make sure not to damage the
hoses.
1
2
7.Remove the polystyrene protection
from the bottom.
8.Pull up the appliance in vertical po-
sition.
9.Remove the power supply cable
and the drain hose from the hose
holders.
10.Remove the three bolts. Use the
key supplied with the appliance.
11.Pull out the plastic spacers.
ENGLISH31
 
						

							12.Put the plastic caps in the holes.
You can find these caps in the user
manual bag.
– We recommend that you
keep the packaging and the
transit bolts for when you
move the appliance.
– If the appliance is delivered in
the winter months when there
are minus temperatures. Store
it at room temperature for 24
hours before using for the first
time.
POSITIONING AND LEVELLING
x4
• Install the appliance on a flat hard
floor.
• Make sure that carpets do not stop
the air circulation below the appli-
ance.
• Make sure that the appliance does
not touch the wall or other units
• Loosen or tighten the feet to adjust
the level. A correct adjustment of the
appliance level prevents the vibra-
tion, noise and the movement of the
appliance when in operation.
32
 
						

							• The appliance must be level and sta-
ble.
CAUTION!
Do not put cardboard, wood or
equivalent materials below the
appliance feet to adjust the lev-
el.
THE INLET HOSE
20O20O20O45O45O45O
• Connect the hose to the appliance.
Turn the inlet hose only left or right.
Loose the ring nut to set it in the cor-
rect position.
• Connect the water inlet hose to the
cold water tap with 3/4 thread.
CAUTION!
Make sure that there are no
leaks from the couplings.
Do not use an extension hose if
the inlet hose is too short. Con-
tact the service centre for the re-
placement of the inlet hose.
ENGLISH33
 
						

							Water-stop device
A
The inlet hose has a water stop device.
This device prevents water leaks in the
hose because of its natural ageing. The
red sector in the window «A» shows this
fault .
If this occur, close the water tap and
contact the service centre to replace
the hose.
WATER DRAINAGE
There are different procedures to con-
nect the drain hose:
With the plastic hose guide.
 
• On the edge of a sink.
• Make sure that the plastic guide can-
not move when the appliance drains.
Attach the guide to the water tap or
the wall.
• To a stand pipe with vent-hole.
Refer to the illustration. Directly into
a drain pipe at a height of not less
than 60 cm and not more than 100
cm. The end of the drain hose must
always be ventilated , i.e. the inner
diameter of the drainpipe must be
larger than the external diameter of
the drain hose.
34
 
						

							Without the plastic hose guide.
•To a sink spigot.
Refer to the illustration. Put the drain
hose in the spigot and tighten it with
a clip. Make sure that the drain hose
makes a loop to prevent that remain-
ing particles go in the appliance from
the sink.
• Directly to a built-in drain pipe in the
room wall and tighten it with a clip.
You can extend the drain hose
to maximum 400 cm. Contact
the service centre for the other
drain hose and the extension.
ENGLISH35
 
						

							www.aeg.com/shop132930200-A-372011