AEG Integrated refrigerator SKS61840S1 User Manual
Here you can view all the pages of manual AEG Integrated refrigerator SKS61840S1 User Manual. The AEG manuals for Refrigerator are available online for free. You can easily download all the documents as PDF.
Page 11
ProblemPossible causeSolution The door is not closed correctly.Refer to "Closing the door". The door has been opened too frequently.Do not keep the door open longer than necessa- ry. The food temperature is too high.Let the food temperature decrease to room temper- ature before storage. The room temperature is too high.Decrease the room tem- perature. Water flows on the rear plate of the re- frigerator.During the automatic de- frosting process, frost de- frosts on the rear plate.This is...
Page 12
Cli- mate classAmbient temperature T+16°C to + 43°C 7.2 Electrical Connection CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electri- cian or competent person. WARNING! This appliance must be earthed. The manufacturer declines any li- ability should these safety meas- ures not be observed. 12 3 4 5 The wires in the mains lead are coloured in accordance with the following code: 1Green and Yellow: Earth 3Brown: Live 5Blue: Neutral As the colours of the...
Page 13
1.Loosen and remove the upper pin. 2.Remove the door. 3.Remove the spacer. 4.With a key, loosen the lower pin. On the opposite side: 1.Tighten the lower pin. 2.Install the spacer. 3.Install the door. 4.Tighten the upper pin. 7.4 Ventilation requirements 5 cmmin. 200 cm2 min. 200 cm2 The airflow behind the appliance must be sufficient. 7.5 Installing the appliance CAUTION! Make sure that the mains cable can move freely.Do the following steps: ENGLISH13
Page 14
x x If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. Ø 2.5 mm 13 mm 1 32 Drill the appliance using a Ø 2.5 mm drill (10 mm max. penetration). Fix the square fitting to the appliance. 1 2 Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the op- posite side of the hinge....
Page 15
44mm 4mm Adjust the appliance in the niche. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm. The lower hinge cover (in the accessories bag) makes sure that the distance be- tween the appliance and the kitchen fur- niture is correct. Make sure that the clearance between the appliance and the cupboard is 4 mm. Open the door. Put the lower hinge cover in position. I I Attach the appliance to the niche with 4 screws. Remove the correct part from the hinge cover (E)....
Page 16
EE B DC Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). 21 mm ~50 mm~50 mm 90 o 90o 90o Install the part (Ha) on the inner side of the kitchen furniture. 16www.aeg.com
Page 17
Ha Hc Push the part (Hc) on the part (Ha). Ha Hb 8 mm Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Remove the small squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. Hb Align the kitchen furniture door and the appliance door by adjusting the part...
Page 18
Hb Hd Press the part (Hd) on the part (Hb). Do a final check to make sure that: • All screws are tightened.• The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly. 7.6 Reversibility of the freezer door 12 12 180 18www.aeg.com
Page 19
8. NOISES There are some sounds during normal running (compressor, refrigerant circula- tion). BRRR!HISSS! CLICK! BLUBB! CRACK! SSSRR R! OK CLICK!CLICK!SSSRRR!SSSRRR! ENGLISH19
Page 20
BRRR!BRRR!HISSS!HISSS! BLUBB!BLUBB!CRACK!CRACK! 9. TECHNICAL DATA Dimension of the recess Height1780 mm Width560 mm Depth550 mm Rising Time 20 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 20www.aeg.com