AEG Integrated fridge freezer SCT81900S0 User Manual

• do not exceed the storage period in-
dicated by the food manufacturer.
5. CARE AND CLEANING
CAUTION!
Unplug the appliance before car-
rying out any maintenance oper-
ation.
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and recharging must
therefore only be carried out by
authorized technicians.
5.1 Periodic cleaning
The equipment has to be cleaned regu-
larly:
• clean the inside and accessories with
lukewarm water and some neutral
soap.
• regularly check the door seals and...

5.2 Defrosting of the refrigerator
Frost is automatically eliminated from
the evaporator of the refrigerator com-
partment every time the motor compres-
sor stops, during normal use. The de-
frost water drains out through a trough
into a special container at the back of
the appliance, over the motor compres-
sor, where it evaporates.
Periodically clean the defrost water drain
hole in the middle of the refrigerator
compartment channel to prevent the wa-
ter overflowing and dripping onto the
food inside....

ProblemPossible causeSolution
The appliance does
not operate. The
lamp does not oper-
ate.The appliance is switched
off.Switch on the appliance.
 The mains plug is not
connected to the mains
socket correctly.Connect the mains plug to
the mains socket correctly.
 The appliance has no
power. There is no volt-
age in the mains socket.Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
The lamp does not
work.The lamp is in stand-by.Close and open the door.
 The...

ProblemPossible causeSolution
Water flows into the
refrigerator.The water outlet is clog-
ged.Clean the water outlet.
 Products prevent that wa-
ter flows into the water
collector.Make sure that products
do not touch the rear
plate.
Temperature cannot
be set .FROSTMATIC or COOL-
MATIC functions switched
on.Switch off FROSTMATIC or
COOLMATIC manually, or
wait to set the temperature
until the function has reset
automatically. Refer to
"FROSTMATIC or COOL-
MATIC function"..
The temperature in
the...

7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
7.2 Electrical Connection
CAUTION!
Any electrical work required to
install...

6.Switch on the appliance.
The appliance is supplied with a 13 amp
plug fitted 
2 . In the event of having to
change the fuse in the plug supplied, a13 amp ASTA approved (BS 1362) fuse
must be used.WARNING!
A cut off plug inserted into a 13
amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
7.3 Door reversibility
The door of the appliance opens to the
right. If you want to open the door to the
left, do these steps before you install the
appliance:
• Loosen the upper pin...

7.4 Ventilation requirements
5 cmmin.
200 cm2
min.
200 cm2
The airflow behind the appliance must
be sufficient.
7.5 Installing the appliance
CAUTION!
Make sure that the mains cable
can move freely.Do these steps.
x
x
If necessary cut the adhesive sealing strip
and then apply it to the appliance as
shown in figure.
A1 A
Drill the hinge cover A, as shown in figure.
Apply the covers A and A1 (in the acces-
sories bag) in to the middle hinge.
ENGLISH17 

1 2
Install the appliance in the niche.
Push the appliance in the direction of the
arrow (1) until the upper gap cover stops
against the kitchen furniture.
Push the appliance in the direction of the
arrow (2) against the cupboard on the op-
posite side of the hinge.
4 mm
44 mm
Adjust the appliance in the niche.
Make sure that the distance between the
appliance and the cupboard front-edge is
44 mm.
The lower hinge cover (in the accessories
bag) makes sure that the distance be-
tween the appliance and the...

Remove the correct part from the hinge
cover (E). Make sure to remove the part
DX, in the case of right hinge, SX in oppo-
site case.
EE
B DC
Attach the covers (C, D) to the lugs and
the hinge holes.
Install the vent grille (B).
Attach the hinge covers (E) to the hinge.
H
H
If the appliance must connect laterally to
the kitchen furniture door:
1.Slacken the screws in fixing brackets
(H).
2.Move the brackets (H).
3.Retighten the screws.
ENGLISH19 

Disconnect the parts (Ha), (Hb), (Hc) and
(Hd).
ca. 50 mm
ca. 50 mm21 mm 90°       
90°       
21 mmInstall the part (Ha) on the inner side of
the kitchen furniture.
Ha
Hc
Push the part (Hc) on the part (Ha).
Ha
Hb
8 mm
Open the appliance door and the kitchen
furniture door at an angle of 90°.
Insert the small square (Hb) into guide
(Ha).
Put together the appliance door and the
furniture door and mark the holes.
20www.aeg.com