AEG Integrated fridge freezer SCN71800S1 User Manual

zen and to make it possible subse-
quently to thaw only the quantity re-
quired;
• wrap up the food in aluminium foil or
polythene and make sure that the
packages are airtight;
• do not allow fresh, unfrozen food to
touch food which is already frozen,
thus avoiding a rise in temperature of
the latter;
• lean foods store better and longer
than fatty ones; salt reduces the stor-
age life of food;
• water ices, if consumed immediately
after removal from the freezer com-
partment, can possibly cause the...

• leave the door/doors ajar to prevent
unpleasant smells.
If the cabinet will be kept on, ask some-
body to check it once in a while to pre-vent the food inside from spoiling in
case of a power failure.
5.3 Defrosting the refrigerator
Frost is automatically eliminated from
the evaporator of the refrigerator com-
partment every time the motor compres-
sor stops, during normal use. The de-
frost water drains out through a drain
hole into a special container at the back
of the appliance, over the motor...

ProblemPossible causeSolution
 The appliance has no
power. There is no volt-
age in the mains socket.Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
The lamp does not
work.The lamp is in stand-by.Close and open the door.
 The lamp is defective.Refer to "Replacing the
lamp".
The buzzer sounds.
The Alarm light
flashing.The temperature in the
freezer is too high.Refer to "High Tempera-
ture Alarm".
The compressor op-
erates continually.The...

ProblemPossible causeSolution
 The door is not closed
correctly.Refer to "Closing the
door".
 The product temperature
is too high.Let the product tempera-
ture decrease to room
temperature before stor-
age.
 Many products are stored
at the same time.Store less products at the
same time.
The temperature in
the refrigerator is
too high.There is no cold air circu-
lation in the appliance.Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too...

7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
7.2 Electrical Connection
CAUTION!
Any electrical work required to
install...

13 amp ASTA approved (BS 1362) fuse
must be used.WARNING!
A cut off plug inserted into a 13
amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
7.3 Door reversibility
The door of the appliance opens to the
right. To open the door to the left, do
these steps before you install the appli-
ance.
• Loosen and remove the upper pin.
• Remove the upper door.
• Remove the spacer.
• Loosen the middle hinge.
• Remove the lower door.
• Loosen and remove the lower pin.
On the...

7.4 Ventilation requirements
5 cmmin.
200 cm2
min.
200 cm2
The airflow behind the appliance must
be sufficient.
7.5 Installing the appliance
CAUTION!
Make sure that the mains cable
can move freely.Do these steps.
x
x
If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
ENGLISH17 

1 2
Install the appliance in the niche.
Push the appliance in the direction of
the arrow (1) until the upper gap cover
stops against the kitchen furniture.
Push the appliance in the direction of
the arrow (2) against the cupboard on
the opposite side of the hinge.
4 mm
44 mm
Adjust the appliance in the niche.
Make sure that the distance between
the appliance and the cupboard front-
edge is 44 mm.
The lower hinge cover (in the accesso-
ries bag) makes sure that the distance
between the appliance and the...

Remove the correct part from the hinge
cover (E). Make sure to remove the part
DX, in the case of right hinge, SX in op-
posite case.
BE
E
DC
Attach the covers (C, D) to the lugs and
the hinge holes.
Install the vent grille (B).
Attach the hinge covers (E) to the hinge.
G
H
Connect the appliance laterally to the
kitchen furniture sidewall:
1.Loosen the screws of the part (G)
and move the part (G) till the furni-
ture sidewall.
2.Tighten the screws of the part (G)
again.
3.Attach the part (H) to the part...

Disconnect the parts (Ha), (Hb), (Hc) and
(Hd).
  
ca. 50 mm
ca. 50 mm21 mm 90°       
90°       
21 mmInstall the part (Ha) on the inner side of
the kitchen furniture.
Ha
Hc
Push the part (Hc) on the part (Ha).
20www.aeg.com