AEG Induction hob HKP65410FB User Manual

comes on. Touch  of the timer to
choose one of the following:
•
 - the sounds are off
•
 - the sounds are on
To confirm your selection wait until the hob deactivates automatically.
When the function is set to 
 you can
hear the sounds only when:
• you touch 
• Minute Minder comes down
• Count Down Timer comes down
• you put something on the control panel.
4.11  Power management
function
• Cooking zones are grouped according to the location and number
of the phases in the hob. See the illustration.
• Each...

2.Touch  for 3 seconds. The display
comes on and goes off
3. Touch 
 for 3 seconds.
4. Touch 
 a few times until  comes
on.
5. Touch 
 of the Timer to select an
automatic mode.
To operate the hood directly
on the hood panel
deactivate the automatic
mode of the function.When you finish cooking and
deactivate the hob, the
hood fan may still operate
for a certain period of time.
After that time the system
deactivates the fan
automatically and prevents
you from accidental
activation of the fan for the
next...

Place the cookware with the bottom
diameter smaller than 160 mm centrally
on a single section.
Place the cookware with the bottom
diameter larger then 160 mm centrally
between two sections.
5.2  FlexiBridge Standard
mode
This mode is active when you activate
the hob. It connects the sections into two
separate cooking zones. You can set the
heat setting for each zone separately. Use two left side control bars.
Correct cookware position:
Incorrect cookware position:
5.3  FlexiBridge Big Bridge
mode
To...

Incorrect cookware position:
5.4 FlexiBridge Max Bridge
mode
To activate the mode press  until you
see the correct mode indicator. This
mode connects all sections into one
cooking zone. To set the heat setting use
one of the left side control bars.
Correct cookware position:
To use this mode you have to place the cookware on the four connected
sections. If you use cookware smaller
than three sections the display shows 
and after 2 minutes the zone switches off.
Incorrect cookware position:
5.5...

General information:
• 160 mm is the minimum bottom diameter of the cookware for thisfunction.
• Heat setting display for the left rear control bar shows the position of the
cookware on the induction cooking
area. Front 
, middle , rear
.
• Heat setting display for the left front control bar shows the heat setting.  To
change the heat setting use left front control bar.
• When you activate the function for the
first time you will get heat setting 
for the front position,  for the
middle position and  for...

The printing on the flexible
induction cooking area may
become dirty or change
colour from sliding the
cookware. You can clean the
area in a standard way.The bottom of the cookware
must be as thick and flat as
possible.
Cookware dimensions
Induction cooking zones adapt to the dimension of the bottom of the
cookware automatically to some limit.
The cooking zone efficiency is related to
the diameter of the cookware. The
cookware with a smaller diameter than
the minimum receives only a part of the power...

Heat settingUse to:Time
(min)Hints7 - 9Steam potatoes.20 - 60Use max. ¼ l water for 750 g of
potatoes.7 - 9Cook larger quantities of food,
stews and soups.60 - 150Up to 3 l liquid plus ingredi-
ents.9 - 12Gentle fry: escalope, veal cor-
don bleu, cutlets, rissoles,
sausages, liver, roux, eggs,
pancakes, doughnuts.as nec-
essaryTurn halfway through.12 - 13Heavy fry, hash browns, loin
steaks, steaks.5 - 15Turn halfway through.14Boil water, cook pasta, sear meat (goulash, pot roast), deep-fry chips.Boil...

7. CARE AND CLEANINGWARNING!
Refer to Safety chapters.7.1  General information
• Clean the hob after each use.
• Always use cookware with clean bottom.
• Scratches or dark stains on the surface have no effect on how the hob
operates.
• Use a special cleaner applicable for the surface of the hob.
• Use a special scraper for the glass.
7.2  Cleaning the hob
•Remove immediately:  melted plastic,
plastic foil, sugar and food with sugar.
If not, the dirt can cause damage to
the hob. Take care to avoid burns....

ProblemPossible causeRemedyAn acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.You put something on one
or more sensor fields.Remove the object from the
sensor fields.The hob deactivates.You put something on the
sensor field 
.
Remove the object from the
sensor field.Residual heat indicator does
not come on. The zone is not hot because
it operated only for a short
time.If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service...

ProblemPossible causeRemedy The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.Use cookware with diameter
applicable to the activated
function or function mode.
Use cookware with diameter
smaller than 160 mm on a
single section of the flexible
induction cooking area.
Refer to "Flexible induction
cooking area" chapter. comes on.Automatic Switch Off oper-
ates.Deactivate the hob and acti-
vate it again. comes on.The Child Safety Device or
the Lock...